R. Alexender, A. S. Varadarajan and P. K. Philip, “Hard Turning with Minimum Cutting Fluid – A Viable Green Alternative on the Shop Floor,” Proceedings of the 18th All India Manufacturing Technology Design and Research Conference, Vol. 1, Kharagpur, 1998, pp. 183- 187.

has been cited by the following article:

• TITLE: Optimization of Surface Milling of Hardened AISI4340 Steel with Minimal Fluid Application Using a High Velocity Narrow Pulsing Jet of Cutting Fluid

  AUTHORS: K. Leo Dev Wins, A. S. Varadarajan, B. Ramamoorthy

  KEYWORDS: Environment Friendly, Pulsed Jet, Minimal Cutting Fluid Application

  JOURNAL NAME: Engineering, Vol.2 No.10, November 29, 2010

  ABSTRACT: Surface milling of hardened steel is carried out with copious supply of cutting fluid and is obviously associated with problems related to procurement and storage of cutting fluid. The disposal of cutting fluid has to comply with environmental legislation such as OSHA regulations. The present investigation proposes an environment friendly minimal pulsed jet cutting fluid application scheme for surface milling of AISI4340 steel with a hardness of 45 HRC using commercially available carbide tools. This scheme can be implemented as such on the shop floor with out the need for any major alternations on the existing facilities and it was observed that the new scheme is not only environment friendly but also provided better cutting performance when compared to conventional wet milling which requires copious supply of cutting fluid.