J. I. Hughes, A. R. C. Sharman and K. Ridgway, “The Effect of Cutting Tool Material and Edge Geometry on Tool Life and Workpiece Surface Integrity,” Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, Vol. 220, No. 2, 2006, pp. 93-107. doi:10.1243/095440506X78192

has been cited by the following article:

• TITLE: Influence of Coolant in Machinability of Titanium Alloy (Ti-6Al-4V)

  AUTHORS: Muthukrishnan Namb, Davim Paulo

  KEYWORDS: Titanium Alloy, Machining, TTI 15 Ceramic Insert, Coolant, Surface, Roughness, Tool Wear

  JOURNAL NAME: Journal of Surface Engineered Materials and Advanced Technology, Vol.1 No.1, March 17, 2011

  ABSTRACT: Application of titanium alloy has increased many fields since the past 50 years. The major drawback encountered during machining was difficult to cut and the formation of BUE (Built up Edge). This paper presents the tool wear study of TTI 15 ceramic insert (80% Aluminum oxide and 20 % Titanium carbide) on machining Ti-6Al-4V at moderate speed with and without the application of water soluble servo cut S coolant. Titanium alloy is highly refractory metal and machining titanium is challenging to the manufacturers. Experiments were carried out on medium duty lathe. Application of coolant tends to reduce toolwear and minimize adhesion of the work material on the cutting tool during machining and also improves the surface finish. Result provides some useful information.