Erratum to “Improvement on Adhesion Properties of Insert Injection Molding Composites: Effect of Inserted Parts, Adhesive Lengths and Injection Conditions” [Open Journal of Composite Materials (2017) 197-206] ()
Abstract
The original online version of this article (Pinpathomrat, B. and Hamada, H. (2017) Improvement on Adhesion Properties of Insert Injection Molding Composites: Effect of Inserted Parts, Adhesive Lengths and Injection Conditions. Open Journal of Composite Materials, 7, 197-206. https://doi.org/10.4236/ojcm.2017.74013) unfortunately contains several mistakes in Figures 1-4, and Figure 6.
Share and Cite:
Pinpathomrat, B. and Hamada, H. (2019) Erratum to “Improvement on Adhesion Properties of Insert Injection Molding Composites: Effect of Inserted Parts, Adhesive Lengths and Injection Conditions” [Open Journal of Composite Materials (2017) 197-206].
Open Journal of Composite Materials,
9, 197-198. doi:
10.4236/ojcm.2019.92010.
Figure 1. Preparation of the insert-injection molded.
Figure 2. Photographs of the insert-injection molded (front view).
Figure 3. Photographs of the insert-injection molded (side view).
Figure 4. Load-displacement curves of adhesive samples at different barrel and mold temperatures. (a) Adhesive length 0 mm; (b) Adhesive length 5 mm.
Figure 6. Schematic of load analysis at the adhesive interface.
Conflicts of Interest
The authors declare no conflicts of interest.
References
[1]
|
Yoshio, N. and Robert, D. (2000) Handbook of Semiconductor Manufacturing Technology. Marcel Dekker, New York.
|
[2]
|
Ryosuke, M., Motoko, S. and Akira T. (2008) Improving Performance of GFRP/Aluminum Single Lap Joint Using Bolted/Co-Cure Hybrid Method. Composites Part A, 39, 154-163.
|
[3]
|
Mohan, N.S., Kulkarni, S.M. and Ramach, A. (2007) Delamination Analysis in Drilling Process of Glass Fiber Reinforced Plastic (GFRP) Composite Materials. Journal of Materials Processing Technology, 186, 265-271.
|
[4]
|
Leong, Y.W., Yamaguchi, S., Mizoguchi, M., Hamada, H., Ishiaku, U.S. and Tsujii, T. (2004) The Effect of Molding Conditions on Mechanical and Morphological Properties at the Interface of Film Insert Injection Molded Polypropylene-Film/Polypropylene Matrix. Polymer Engineering and Science, 44, 2327-2334.
https://doi.org/10.1002/pen.20260
|
[5]
|
Mao, W., Wyatt, T.P., Chen, J. and Wang, J. (2015) Insert Injection Molding of High-Density Polyethylene Single-Polymer Composites. Polymer Engineering and Science, 55, 2448-2456. https://doi.org/10.1002/pen.24132
|
[6]
|
Pinpathomrat, B., Mathurosemontri, S., Uawongsuwan, P., Thumsorn, S. and Hamada H. (2016) Study on Adhesive Property of Insert Injection Molded Glass Fiber Reinforced Polypropylene Composites. Energy Procedia, 89, 291-298.
|