Operating Characteristics of Multiple Evaporators and Multiple Condensers Loop Heat Pipe with Polytetrafluoroethylene Wicks - Journal of Electronics Cooling and Thermal Control

JECTC > Vol.4 No.1, March 2014

Journal of Electronics Cooling and Thermal Control

Volume 4, Issue 1 (March 2014)

ISSN Print: 2162-6162 ISSN Online: 2162-6170

Google-based Impact Factor: 0.25 Citations

Operating Characteristics of Multiple Evaporators and Multiple Condensers Loop Heat Pipe with Polytetrafluoroethylene Wicks ()

HTML

Download as PDF (Size: 4567KB) PP. 22-32

DOI: 10.4236/jectc.2014.41003 5,640 Downloads 8,374 Views Citations

Author(s)

Sho Okutani, Hosei Nagano, Shun Okazaki, Hiroyuki Ogawa, Hiroki Nagai

Affiliation(s)

Department of Aerospace Engineering, Nagoya University, Nagoya, Japan.
Department of Aerospace Engineering, Tohoku University, Sendai, Japan.
Japan Aerospace Exploration Agency, Sagamihara, Japan.

ABSTRACT

This paper presents fabrication and testing of a multiple-evaporator and multiple-condenser loop heat pipe (MLHP) with polytetrafluoroethylene (PTFE) porous media as wicks. The MLHP has two evaporators and two condensers in a loop heat pipe in order to adapt to various changes of thermal condition in spacecraft. The PTFE porous media was used as the primary wicks to reduce heat leak from evaporators to compensation chambers. The tests were conducted under an atmospheric condition. In the tests that heat loads are applied to both evaporators, the MLHP was stably operated as with a LHP with a single evaporator and a single condenser. The relation between the sink temperature and the thermal resistance was experimentally evaluated. In the test with the heat load to one evaporator, the heat transfer from the heated evaporator to the unheated evaporator was confirmed. In the heat load switching test, in which the heat load is switched from one evaporator to another evaporator repeatedly, the MLHP could be stably operated. The loop operation with the large temperature difference between the heat sinks was also tested. From this result, the stable operation of the MLHP in the various conditions was demonstrated. It was also found that a flow regulator which prevents the uncondensed vapor from the condensers is required at the inlet of the common liquid line when one condenser has higher temperature and cannot condense the vapor in it.

KEYWORDS

Loop Heat Pipe; Multiple Evaporators; Multiple Condensers; Thermal Control; Two-Phase Heat Transfer

Share and Cite:

Okutani, S. , Nagano, H. , Okazaki, S. , Ogawa, H. and Nagai, H. (2014) Operating Characteristics of Multiple Evaporators and Multiple Condensers Loop Heat Pipe with Polytetrafluoroethylene Wicks. Journal of Electronics Cooling and Thermal Control, 4, 22-32. doi: 10.4236/jectc.2014.41003.

Cited by

[1]	Experimental investigation on the start-up performance of a loop heat pipe with three flat disk evaporators combined
	Applied Thermal Engineering, 2022

[2]	Experimental Investigations on performance analysis of a wickless thermosiphon heat pipe with two heat sources and multiple branches
	Journal of …, 2022

[3]	Operating characteristics of a dual flat-evaporator loop heat pipe for single heat source cooling in any orientation
	2021

[4]	Experimental study on the startup performance of dual-evaporator loop heat pipes
	International Journal of Thermal …, 2021

[5]	Study on Temperature Oscillation mechanism of flat-type Loop Heat Pipe
	2020

[6]	TEMPERATURE OSCILLATION MECHANISM OF A FLAT-TYPE LOOP HEAT PIPE
	2020

[7]	Development and testing multiple evaporator loop heat pipe utilizing three way T port valve
	2020

[8]	Various orientations research on thermal performance of novel multi-branch heat pipes with different sintered wicks
	Energy Conversion and Management, 2018

[9]	A review of thermal performance in multiple evaporators loop heat pipe
	Applied Thermal Engineering, 2018

[10]	Experimental investigation of the thermal performance of heat pipe with multi-heat source and double-end cooling
	Applied Thermal Engineering, 2018

[11]	Utilisation of Passive Thermal Control Technologies for Electronics Cooling: A Brief Review
	2017

[12]	Experimental investigation on a novel multi-branch heat pipe for multi-heat source electronics
	International Journal of Heat and Mass Transfer, 2017

[13]	Utilization of Passive Thermal Control Technologies for Electronics Cooling: A Brief Review
	2016

[14]	UTILIZATION OF PASSIVE THERMAL CONTROL TECHNOLOGIES IN COOLING ELECTRONICS: A BRIEF REVIEW
	2016

[15]	Utilisation of Passive Thermal Control Technologies for Electronics Cooling: A Brief
	2016

[16]	高性能鐵氟龍毛細結構應用於迴路式熱管之研究
	臺灣大學學位論文, 2015

[17]	マルチエバポレータ型ループヒートパイプの内部流動特性に関する研究 (微小重力環境下での蒸発器及び凝縮器の可視化)
	日本機械学会論文集, 2015

[18]	Mathematical modeling of multiple evaporators/condensers loop heat pipe operation with flow regulator under various operating conditions
	Journal of Thermal Science and Technology, 2015

[19]	Visualization of Loop Heat Pipe with Multiple Evaporators under Microgravity
	2015

Journals Menu

Follow SCIRP

	+1 323-425-8868
	customer@scirp.org
	+86 18163351462(WhatsApp)
	1655362766

	Paper Publishing WeChat

Journals Menu

Home

About SCIRP

Service

Policies