Dangayach, G.S. and Guglani, L. (2015) Application of Moldflow and Taguchi Technique in Improving the Productivity of Injection Moulded Energy Meter Base. International Journal of Process Management and Benchmarking, 5, 375-385.
https://doi.org/10.1504/IJPMB.2015.070820

has been cited by the following article:

• TITLE: Study on Flow and Warpage of Windshield Complex Parts Based on Moldflow

  AUTHORS: Jihong Zuo, Lei Wang, Lili Liu, Shuai Li, Miao Peng

  KEYWORDS: Special-Shaped Parts, Moldflow Software, Gate Position, Flow Analysis, Warpage Analysis

  JOURNAL NAME: Open Journal of Applied Sciences, Vol.15 No.3, March 18, 2025

  ABSTRACT: It is difficult to form the inner windshield plastic parts, using Moldflow software on the flow analysis of plastic parts, and designing different input plans; the analysis shows that although the four-gate injection pressure has severe fever but the preparation temperature and the number of fusion traces satisfy Functional requirements; and warped analysis results indicate that X-direction, Y, Z, and Z to warpage deformation values are within the tolerance requirements of the plastic parts.