Patil, R. and Gawande, R. (2016) Performance of a Forced Convection Solar Tunnel Dryer with and without Thermal Storage for Drying of Tomatoes. International Journal of Engineering Research in Mechanical and Civil Engineering, 1, 111-116.

has been cited by the following article:

• TITLE: Design and Development of a Parabolic Trough Solar Air Heater for a Greenhouse Dryer

  AUTHORS: Eric King’ori, Isaac N. Simate

  KEYWORDS: Solar Air Heater, Greenhouse Dryer, Parabolic Trough, Thermal Performance

  JOURNAL NAME: Journal of Power and Energy Engineering, Vol.12 No.9, September 10, 2024

  ABSTRACT: Design and Development of a Parabolic Trough Solar Air Heater (PTSAH) for a Greenhouse Dryer (GD) was done to improve the dryer’s performance. The materials used for the fabrication of the PTSAH included galvanized sheets covered with aluminium foil, an absorber tube made of GI pipe painted matt black to increase heat absorbance at the focal line, mild steel square tubes, shutter plywood, and an axial fan to push air through the absorber tube. Key geometrical parameters used for the design of the PTSAH were a rim angle of 98 degrees, focal length of 0.2608 m, height of 0.3451 m, length of 2 m, and an aperture width of 1.2 m. The PTSAH’s total aperture surface area was 2.4 m2, while its absorber tube surface area was 0.1587 m2. The PTSAH was experimentally tested to establish its thermal performance. It was found that the ambient air recorded an average value of 31.1˚C and that the air heater could increase the air temperature by 45.6˚C above ambient with a thermal efficiency of 5.3%. It can, therefore, be concluded that the PTSAH can significantly improve the performance of a GD by supplying the GD with air at a higher temperature than ambient.