TITLE:
Effect of Lithium Chloride on the Fibre Length Distribution, Processing Temperature and the Rheological Properties of High-Yield-Pulp-Fibre-Reinforced Modified Bio-Based Polyamide 11 Composite
AUTHORS:
Robenson Cherizol, Mohini Sain, Jimi Tjong
KEYWORDS:
HYP/PA11, Melting Temperature of Nylon 11, Inorganic Salt Chloride Lithium (Licl), Fibre Aspect Ratio and Length Distribution, Rheological Characteristic
JOURNAL NAME:
Advances in Nanoparticles,
Vol.6 No.2,
April
13,
2017
ABSTRACT: The aim of this work was to investigate the effect of lithium chloride (LiCl) on the fibre length distribution, melting temperature and the rheological characteristics of high yield pulp fibre reinforced polyamide biocomposite. The inorganic salt lithium chloride (LiCl) was used to decrease the melting and processing temperature of bio-based polyamide 11. The extrusion method and Brabender mixer approaches were used to carry out the compounding process. The densities and fibre content were found to be increased after processing using both compounding methods. The HYP fibre length distribution analysis realized using the FQA equipment showed an important fibre-length reduction after processing by both techniques. The rheological properties of HYP-reinforced net and modified bio-based polyamide 11 “PA11” (HYP/PA11) composite were investigated using a capillary rheometer. The rheological tests were performed in function of the shear rate for different temperature conditions. The low-temperature process compounding had higher shear viscosity; this was because during the process the temperature was low and the mixing and melting were induced by the high shear rate created during compounding process. Experimental test results using the extrusion process showed a steep decrease in shear viscosity with increasing shear rate, and this melt-flow characteristic corresponds to shear-thinning behavior in HYP/PA11, and this steep decrease in the melt viscosity can be associated to the hydrolyse reaction of nylon for high pulp fibre moisture content at high temperature. In addition to the low processing temperature, the melt viscosity of the biocomposite using the Brabender mixer approach increases with increasing shear rate, and this stability in the increase even at high shear rate for high pulp moisture content is associated to the presence of inorganic salt lithium chloride which creates the hydrogen bonds with pulp during the compounding process.