Asuke, F., Aigbodion, V.S., Abdulwahab, M., Fayomi, O.S.I., Popoola, A.P.I., Nwoyi, C.I. and Garba, B. (2012) Effects of Bone Particle on the Properties and Microstructure of Polypropylene/Bone Ash Particulate Composites. Results in Physics, 2, 135-141. http://dx.doi.org/10.1016/j.rinp.2012.09.001

has been cited by the following article:

• TITLE: A Comparative Study on Dry Sliding Wear Characteristics of Al2O3 and Bone Powder Filled Hybrid Composites

  AUTHORS: Sudeep Deshpande, T. Rangaswamy

  KEYWORDS: Al2O3, Bone Powder, Wear Test, Taguchi Analysis, SEM

  JOURNAL NAME: Journal of Minerals and Materials Characterization and Engineering, Vol.4 No.2, March 30, 2016

  ABSTRACT: The aim of the research was to develop E-glass/jute fiber reinforced epoxy composites with an addition of Al2O3 and bone powder by using hand layup technique and to compare tribological properties of these composites under similar test conditions. The wear experiments were designed according to Taguchi’s (L27) orthogonal array with three control variables such as sliding velocity, filler content and normal load. The results indicated that the normal load for Al2O3 and filler content for bone powder emerged as the significant factors affecting specific wear rate of hybrid composites. An addition of 10 wt% of bone powder or Al2O3 into E-glass/jute fiber reinforced epoxy composites increased the wear resistance considerably, and natural waste bone powder can be used instead of ceramic filler Al2O3 in hybrid composites. After the analysis of control factors, an optimal factor setting has been suggested for specific wear rate and coefficient of friction. Further, the scanning electron microscopy (SEM) images for worn surfaces of hybrid composites were studied. Finally, a confirmation test was carried out to validate the results.