Exergetic Analysis of Solar Energy drying Systems

B.O. Bolaji
DOI: 10.4236/nr.2011.22012                

Abstract

An exergetic analysis of three basic types of solar drying systems is presented. The analysis is used to find the available useful energy and the quality of energy that is obtainable from the dryers. The dryers were installed side by side and tested simultaneously to eliminate influence of solar radiation and environmental changes in comparing their performances. The results obtained show that mixed mode and indirect mode solar dryers are more effective in utilizing the captured energy than direct mode dryer, and mixed mode has a slight edge in superiority over indirect mode system. 78.1% and 77% of energy collected in the mixed mode and indirect mode systems, respectively, were available as useful energy, while direct mode system could only convert 49.3% of collected energy to useful energy. The overall exergetic efficiencies of mixed mode, indirect mode and direct mode systems were found to be 55.2%, 54.5% and 33.4%, respectively.

Keywords

Solar, Exergy, Direct, Indirect, Mixed Mode, Dryer

Conflicts of Interest

The authors declare no conflicts of interest.

References

[1]	D. Ivanova and K. Andonov, “Analytical and Experimental Study of Combined Fruit and Vegetable Dryer,” Energy Con-version and Management, Vol. 42, No. 8, 2001, pp. 975-983. doi:10.1016/S0196-8904(00)00108-4
[2]	A. Akbulut and A. Durmus, “Energy and Exergy Analyses of Thin Layer Drying of Mulberry in a Forced Solar Dryer,” Energy, Vol. 35, No. 4, 2010, pp. 1754-1763. doi:10.1016/j.energy.2009.12.028
[3]	P. P. Singh, S. Singh and S. S. Dhaliwal, “Multi-Shelf Domestic Solar Dryer,” Energy Conversion and Management, Vol. 47, No. 13-14, 2006, pp. 1799-1815. doi:10.1016/j.enconman.2005.10.002
[4]	P. P. Tripathy and S. Kumar, “Modeling of Heat Transfer and Energy Analysis of Potato Slices and Cylinders During Solar Drying,” Applied Thermal Engineering, Vol. 29, 2009, pp. 884-891. doi:10.1016/j.applthermaleng.2008.04.018
[5]	M. A. Karim and M. N. A. Hawlader, “Development of Solar Air Collectors for Drying Applications,” Energy Conversion and Management, Vol. 45, 2004, pp. 329-344. doi:10.1016/S0196-8904(03)00158-4
[6]	A. A. El-Sebaii and H. Al-Snani, “Effect of Selective Coating on Thermal Per-formance of Flat Plate Solar Air Heaters,” Energy, Vol. 35, 2010, pp. 1820-1828. doi:10.1016/j.energy.2009.12.037
[7]	E. K. Akpinar and Y. Bicer, “Mathematical Modelling of Thin Layer Drying Process of Long Green Pepper in Solar Dryer and under Open Sun,” Energy Conversion and Management, Vol. 49, No. 6, 2008, pp. 1367-1375. doi:10.1016/j.enconman.2008.01.004
[8]	B. O. Bolaji and A. P. Olalusi, “Performance Evaluation of a Mixed-Mode Solar Dryer,” AU Journal of Technology, Vol. 11, No. 4, 2008, pp. 225-231.
[9]	E. K. Akpinar, “Drying of Mint Leaves in a Solar Dryer and under Open Sun: Modelling, Performance Analyses,” Energy conversion and management, Vol. 51, No. 12, 2010, pp. 2407-2418. doi:10.1016/j.enconman.2010.05.005
[10]	B. O. Bolaji, O. S. Olokode and A. P. Olalusi, “Development of a Wind-Ventilated Box-Type Absorber Solar Air Collector,” International Journal of Agricultural Sciences, Science, Envi-ronment and Technology, Vol. 7, No. 1, 2008, pp. 18-29.
[11]	I. N. Itodo, S. E. Obetta and A. A. Satimehin, “Evaluation of a Solar Crop Dryer for Rural Applications in Nigeria,” Botswana Journal of Technology, Vol. 11, No. 2, 2002, pp. 58-62.
[12]	M. K. Gupta and S. C. Kaushik, “Exer-getic Performance Evaluation and Parametric Studies of Solar Air Heater,” Energy, Vol. 33, 2008, pp. 1691-1702. doi:10.1016/j.energy.2008.05.010
[13]	C. O. Adegoke and B. O. Bolaji, “Exergetic Analysis of Thermosyphon Solar Water Heating Systems,” Nigerian Journal of Renewable Energy, vol. 7, 1999, pp. 50-54.
[14]	C. O. Adegoke and B. O. Bolaji, “Performance Evaluation of Solar-Operated Thermosyphon Hot Water System in Akure,” International Journal of Engi-neering and Engineering Technology, Vol. 2, No. 1, 2000, pp. 35-40.