Author(s)

Ahmad Abdallah Rahhal

Department of orthodontics, Faculty of Dentistry, Arab American University, Jenin, Palestine.

Treatment of skeletal Cl II includes functional orthopedic treatment, head-gears, extraction of the upper premolars and orthognathic surgery. To treat any patient with functional appliances (bite jumping) an adequate overjet is necessary. In this case an 11 years old female patient has skeletal CLII due to mandibular deficiency with ANB angle 8 degrees, overbite: 3 mm, overjet: 1 mm, extremely convex profile and underdeveloped chin due to the hyper muscle contraction of the lower lip to obtain oral seal. To obtain an adequate overjet lower first premolars were extracted and maximum retraction using mini screws (for maximum anchorage) was applied. Afterwards Rahhal functional appliance was used by the patient 16 hours a day for 6 months and 10 hours a day for another 6 months for retention. After that fixed orthodontic treatment was completed. Lateral cephalometrics were taken, traced and analyzed. In the result Skeletal CLI was obtained (ANB 4 degree), straight facial profile, normal over bite overjet and particular chin development were noticed. As a conclusion, in skeletal CLII malocclusions, lower incisor protrusion will cause a contraindication for functional treatment. Extraction of the lower premolars and retraction of the lower incisors followed by functional orthopedic treatment is an efficient method to treat these cases instead of waiting for orthognathic surgery, also reducing the muscle pressure on the chin will change the development characteristics of it.

Rahhal Functional Appliance, Lower Incisor Protrusion, Minimum Overjet, Maximum Anchorage, Chin Development

Rahhal, A. (2018) Treatment of Skeletal CL II Patient with Maximum Lower Incisor Protrusion and Minimum Overjet with Rahhal Functional Appliance. Open Journal of Stomatology, 8, 319-325. doi: 10.4236/ojst.2018.812030.