Author(s)

Alan Sepulveda-Rodríguez¹, Felipe Guerrero-Martínez², César Gaitan-Fonseca¹, Takashi Komabayashi³, Enrique Reyes-Vela¹, David Masuoka¹

¹Department of Stomatology, Universidad Autónoma de Aguascalientes, Aguascalientes, Mexico.
²Faculty of Dentistry, Universidad Autónoma de San Luis Potosí, San Luis Potosí, Mexico.
³Department of Endodontics, West Virginia University, Charleston, USA.

The aim of this study is to evaluate the maximum and minimum distances between the model and the cast crown of three techniques using Scanning Electron Microscopy (SEM). Three technique groups were used for this study: group A (control), traditional manual wax patterns; group B, dipping wax patterns; group C, resin patterns made with CAD/CAM. For each group, 10 samples were made using the same model, and then metal cast. Marginal accuracies of the samples were evaluated by performing gap measurements using SEM with a magnification of 1200× (minimum distance). The data were statistically analyzed using the one-way analysis of variance (ANOVA) at the 0.05 significance level. The average (standard deviation) of the minimum distance [μm] was 22.5 (12.1), 9.9 (4.3), and 14.7 (6.6), in groups A, B, and C, respectively. The average standard deviation of gap area [μm²] was 21667.2 (3476.4), 9906.4 (1512.1), and 16048.8 (8123). In the minimum distance comparison, groups A and B (p = 0.006) showed statistically significant results. In the gap area comparison, there was no statistical significance among groups A, B, and C (p = 0.174). The marginal adaptations of all three techniques were within a reported clinically acceptable range of margin.

Marginal Adaptation, CAD/CAM, Metal Caps, Wax Pattern

Sepulveda-Rodríguez, A. , Guerrero-Martínez, F. , Gaitan-Fonseca, C. , Komabayashi, T. , Reyes-Vela, E. and Masuoka, D. (2015) Evaluation of the Marginal Adaptation in Metal Crowns Using CAD/CAM and Manual Wax Patterns. Microscopy Research, 3, 26-32. doi: 10.4236/mr.2015.32004.