A New Kind of Renewable Energy: Production of Aromatic Hydrocarbons Naphtha Chemical by Thermal Degradation of Polystyrene (PS) Waste Plastic

Moinuddin Sarker, Mohammad Mamunor Rashid, Muhammad Sadikur Rahman, Mohammed Molla

Natural State Research, Inc. Department of Research and Development, 37 Brown House Road (2nd Floor), Stamford, CT 06902, USA.

DOI: 10.4236/ajcc.2012.13012                

Abstract

Polystyrene (PS) waste plastic to renewable energy or naphtha grade fuel production through fractional distillation process was applied and PS liquefaction temperature range was 250?C - 430?C and fractional column temperature was 110?C - 135?C for naphtha grade fuel separation. The thermal degradation of PS waste plastic to renewable energy or naphtha grade chemical production was without adding any kind of cracking catalyst and without vacuum system. Polystyrene waste plastic is not bio-degradable and its can remain long period of landfill and creating gas emission for that reason its major cause climate change. For experimental purpose raw sample was use 1 kg of PS waste plastic and experiment was performed under Labconco fume hood and experiment was fully closed system, whole experiment was performed into stainless steel reactor. Produced fuel was analysis by gas chromatography and mass spectrometer, FT-IR and DSC. Analysis result indicate for fuel compounds chemical structure, compound band energy and enthalpy, delta H value. Produced fuel sulfur content less then environmental protection agency (EPA) level and fuel could be use for chemical feedstock refinery for further modification. By using this technology can reduce some foreign oil dependency and boost up renewable energy sector all over the world.

Keywords

Renewable Energy; Climate Change; Polystyrene; Aromatic; Naphtha; Waste Plastic; Thermal Degradation; GC/MS

Conflicts of Interest

The authors declare no conflicts of interest.

References

[1]	W. Kaminsky, I. J. N. Zorriqueta, “Catalytical and thermal pyrolysis of polyolefins,” J. Anal. Appl. Pyrol., Vol. 79, 2007, pp: 368.
[2]	M. Predel, W. Kaminsky, “Pyrolysis of mixed polyolefins in a fluidised-bed reactor and on a pyro-GC/MS to yield aliphatic waxes,” Polym. Degrad. Stab., Vol.70, 2000, pp: 373.
[3]	R. Aguado, M. Olazar, M. J. San Jose, B. Gaisan, J. Bilbao, “Wax formation in the pyrolysis of polyolefins in a conical spouted bed reactor,” Energy Fuels, Vol. 16, 2002, pp: 1429.
[4]	A. Marcilla, M. I. Beltran, R. Navarro, “Study of the deactivation process of HZSM5 zeolite during polyethylene pyrolysis,” Appl. Catal., A Vol. 57, 2007, pp: 333.
[5]	A. Marcilla, A. Gomez, S. Menargues, “TGA/FTIR study of the evolution of the gases evolved in the catalytic pyrolysis of ethylene-vinyl acetate copolymers. Comparison among different catalysts.,” Polym. Degrad. Stab., Vol. 89, 2005, pp: 454.
[6]	M. R. Hernandez, A. N. Garcia, A. Marcilla, “Catalytic flash pyrolysis of HDPE in a fluidized bed reactor for recovery of fuel-like hydrocarbons,” J. Anal. Appl. Pyrol.Vol.78, 2007, pp: 272.
[7]	A. Marcilla, A. Gomez-Siurana, D. Berenguer, “Study of the early deactivation in pyrolysis of polymers in the presence of catalysts,” J. Anal. Appl. Pyrol. Vol.79, 2007, pp: 443.
[8]	S. C. Cardona, A. Corma, “Tertiary recycling of polypropylene by catalytic cracking in a semibatch stirred reactor: Use of spent equilibrium FCC commercial catalyst,” Appl. Catal., B, Vol.25, 2000, pp: 151.
[9]	S. Chaianansutcharit, R. Katsutath, A. Chaisuwan, T. Bhaskar, A. Nigo, A. Muto, Y. Sakata, “Catalytic degradation of polyole-fins over hexagonal mesoporous silica: Effect of aluminum addition,” J. Anal. Appl.Pyrol.Vol.80, 2007, pp: 360.
[10]	S. Ali, A. A. Garforth, D. H. Harris, D. J. Rawlence, Y. Uemichi, “Polymer waste recycling over “used” catalysts,” Catal. Today, Vol.75, 2002, pp: 247.
[11]	A. Marcilla, M. I. Beltran, R. Navarro, “Thermal and catalytic pyrolysis of polyethylene over HZSM5 and HUSY zeolites in a batch reactor under dynamic conditions,” Appl. Catal., B 2008, in press.
[12]	J. Mertinkat, A. Kirsten, M. Predel, W. Kaminsky, “Cracking catalysts used as fluidized bed material in the Hamburg pyrolysis process,” J. Anal. Appl. Pyrol., Vol.49, 1999, pp: 87.
[13]	M. R. Hernandez, A. Gomez, A. N. Garcia, J. Agullo, A. Marcilla, “Effect of the temperature in the nature and extension of the primary and secondary reactions in the thermal and HZSM-5 catalytic pyrolysis of HDPE,” Appl. Catal., A Vol. 183, 2007, pp:317.
[14]	J. Scheirs, W. Kaminsky, “Feedstock Recycling and Pyrolysis of Waste Plastics,” Wiley Series; Wiley: Chichester, U.K., 2006.
[15]	J. M. Arandes, M. J. Azkoiti, I. Torre, M. Olazar, P. Castano, “Effect of HZSM-5 catalyst addition on the cracking of polyolefin pyrolysis waxes under FCC conditions,” Chem. Eng. J., Vol.17, 2007, pp: 132,
[16]	J. Aguado, D. Serrano, “Feedstock Recycling of Plastic Wastes,” Royal Society of Chemistry: Cambridge, U.K., 1999.
[17]	A. Marcilla, M. I. Beltran, and R. Navarro, “Evolution with the Temperature of the Compounds Obtained in the Catalytic Pyrolysis of Polyethylene over HUSY,” Ind. Eng. Chem. Res., Vol.47, 2008, pp: 6896–6903.
[18]	M. W. Rosegrant, “Biofuels and grain prices: impacts and policy responses,” International Food Policy Research Institute: Washington, DC, 2008.
[19]	W. L. Yoon, J. S. Park, H. Park, Jung, H. T. Lee, D. K. Lee, “Optimization of pyrolytic coprocessing of waste plastics and waste motor oil into fuel oils using statistical pentagonal experimental design,” Fuel, Vol. 78, No.7, 1999, pp:809–813.
[20]	N. Miskolczi, A. Angyal, L. Bartha, I. Valkai, “Fuels by pyrolysis of waste plastics from agricultural and packaging sectors in a pilot scale reactor,” Fuel Process. Technol., Vol.90, 2009, pp: 1032–1040.
[21]	S. M. Al-Salem, P. Lettieri, J. Baeyens, “Recycling and recovery routes of plastic solid waste (PSW): A review,” Waste Manage., Vol.29, 2009, pp:2625–2643.
[22]	S. M. Al-Salem, P. Lettieri, J. Baeyens, “The valorization of plastic solid waste (PSW) by primary to quaternary routes: From reuse to energy and chemicals,” Prog. Energy Combust. Sci., Vol.36, 2010, pp: 193–129.
[23]	S. J. Miller, “Conversion of waste plastic to lubricating base oil,” Energy Fuels, Vol.19, 2005, pp: 1580–1586.
[24]	K. Smolders, J. Baeyens, “Thermal degradation of PMMA in fluidized beds,” Waste Manage, Vol.24, 2004, pp: 849–857.
[25]	M. P. Aznar, M. A. Caballero, J. A. Sancho, E. France’s, “Plastic waste elimination by cogasification with coal and biomass influidized bed with air in pilot plant,” Fuel Process. Technol., Vol.87, 2006, pp: 409–420.
[26]	A. Demirbas, “Pyrolysis of municipal plastic wastes for recovery of gasoline-range hydrocarbons,” J. Anal. Appl. Pyrolysis, Vol.72, No.1, 2004, pp: 97–102.
[27]	E. A. Williams, P. T. Williams, “Analysis of products derived from the fast pyrolysis of plastic waste,” J. Anal. Appl. Pyrolysis, Vol.40-41, 1997, pp: 347–363.
[28]	J. Ahrenfeldt, “Characterization of biomass producer gas as fuel for stationary gas engines in combined heat and power production,” Ph.D. Thesis, Technical University of Denmark, Lyngby, Denmark, 2007.
[29]	T. Bhaskar, M.A. Uddin, A. Muto, Y. Sakata, Y. Omura, K. Kimura, Y. Kawakami, “Recycling of waste lubricant oil into chemical feedstock or fuel oil over supported iron oxide catalysts,” Fuel, Vol.83, No.1, 2004, pp: 9–15.
[30]	A. Demirbas, “Biodiesel: A Realistic Fuel Alternative for Diesel Engines,” Springer, London, U.K., 2008.
[31]	Y. S. Kim, Y. S. Kim, K. M. Kim, S. U. Jeong, S. H. Kim, “Thermal decomposition kinetics of polymeric wastes using a nonisothermal thermogravimetric method,” J. Ind. Eng. Chem., Vol.9, No.3, 2003, pp: 219–224.
[32]	S. Kim, S. Kim, “Pyrolysis characterixtics of polystyrene and polypropylene in a stirred batch reactor,” Chem. Eng. J., Vol.98, 2004, pp: 53–60.
[33]	S. Lovett, F. Berruti, L. A. Behie, “Ultrapyrolytic upgrading of plastic wastes and plastics/heavy oil mixtures to valuable light gas products,” Ind. Eng. Chem. Res., Vol.36, 1997, pp: 4436–4444.
[34]	H. Bockhorn, A. Hornung, U. Hornung, D. Schawaller, “Kinetic study on the thermal degradation of poly-propylene and polyethylene,” J. Anal. Appl. Pyrolysis, Vol.48, No.2, 1999, pp: 93–109.
[35]	Y. S. Kim, Y. S. Kim, S. H. Kim, “Investigation of Thermodynamic Parameters in the Thermal Decomposition of Plastic Waste-Waste Lube Oil Compounds,” Environ. Sci. Technol., Vol.44, 2010, pp: 5313–5317.
[36]	REN21 (2011). “Renewables 2011: Global Status Report”. p.17-18, Available online at http://www.ren21.net/Portals/97/documents/GSR/GSR2011_Master18.pdf.
[37]	William Moomaw, Francis Yamba, Renewable Energy and Climate Change, available online at http://srren.ipcc-wg3.de/report/IPCC_SRREN_Ch01.pdf
[38]	A. Oberheitmann, “Development of a Low Carbon Economy in Wuxi City,” American Journal of Climate Change, Vol. 1 No. 2, 2012, pp. 64-103. doi: 10.4236/ajcc.2012.12007.
[39]	Z. Yang, “The Right to Carbon Emission: A New Right to Development,” American Journal of Climate Change, Vol. 1 No. 2, 2012, pp. 108-116. doi: 10.4236/ajcc.2012.12009.
[40]	P. Soderholm, “Modeling the Economic Costs of Climate Policy: An Overview,” American Journal of Climate Change, Vol. 1 No. 1, 2012, pp. 14-32. doi: 10.4236/ajcc.2012.11002.