Author(s)

Azhari Muhammad Syam, Leni Maulinda, Ishak Ibrahim, Syafari Muhammad

Department of Chemical Engineering, Malikussaleh University, Lhokseumawe, Indonesia; 2Institute of Advanced Technology, Un-iversiti Putra Malaysia, Serdang, Malaysia..
Department of Chemical Engineering, Malikussaleh University, Lhokseumawe, Indonesia; Institute of Advanced Technology, Universiti Putra Malaysia, Serdang, Malaysia..

The conversion of waste frying oil into a valuable methyl ester (biodiesel) has been successfully conducted and also the acid pre-treatment process was carried out prior to the main biodiesel production process for lowering waste frying oil free fatty acid (FFA) content below 1%. The physicochemical properties of biodiesel were analyzed to ensure the product could meet the standards of fuel properties. The methanolysis was selected as the biodiesel production technique under various mixing speeds namely 350, 400 and 450 rpm, while the other parameters are maintained at the optimum process conditions such as methanol to oil molar ratio is 6:1, percentage of catalyst loading is 1.0% wt, reaction temperature is 60℃, and reaction time is 50 min. Also, the investigation on the kinematic viscosity, density and flash point of biodiesel was performed against a number of rpm. The standards of ASTM D 6751 were applied to measure the entire prescribed properties of biodiesel. The highest yield of biodiesel obtained was 99%. The values of flash point, kinematic viscosity and density were in the range of specified limitations. Other biodiesel properties fulfilled the diesel engine application requirements.

Waste Frying Oils; Biodiesel; Fuel Properties

A. Syam, L. Maulinda, I. Ibrahim and S. Muhammad, "Waste Frying Oils-Based Biodiesel: Process and Fuel Properties," Smart Grid and Renewable Energy, Vol. 4 No. 3, 2013, pp. 281-286. doi: 10.4236/sgre.2013.43034.