Using Tallquist Haemoglobin Scale for Estimating Intraoperative Blood Loss in Liposuction ()
1. Introduction
Intraoperative blood loss remains as a concern for all surgeons. Proper estimation of intraoperative blood loss is critical and can be challenging, especially if the blood is mixed with other fluids such as tumescent fluid in liposuction cases. In such cases, proper estimation of intraoperative blood loss will lead to fewer mistakes in fluid resuscitation and protecting patients from under or over fluid balance correction.
To understand fluid balance in liposuction cases, two definitions should be covered:
1) Intraoperative fluid ratio 8: defined as the volume of super-wet solution and intraoperative intravenous fluid divided by the aspiration volume.
Trott et al., stated that it should be 2.1 for small-volume (aspirate < 4000 cc) and 1.4 for large-volume (aspirate > 4000 cc) [1] .
Rohrich et al., revised the ratio to be 1.8 for the small-volume reductions (aspirate < 5000 cc) and 1.2 for the large-volume reductions (aspirate > 5000 cc) [2] .
2) Final residual fluid volume: all intakes and outputs should be meticulously measured as follows: residual fluid volume = (total fluid volume in) − (total volume out); total fluid volume in = (total fluid volume of wetting solution used) + (total volume of IV fluid used) + (volume of bupivacaine/steroid solution); and total volume out = [total volume of aspirated wetting solution (which is approximately 30% of the total aspirated volume in most cases)] + urine output [3] .
The average residual volume by Wang et al. [3] was around 110 mL/kg, and was 120 mL/kg in the report of Commons et al. [4] .
IV fluid infused intraoperatively should equal:
1) Fasting deficit: hourly maintenance*number of fasting hours.
2) Hourly maintenance: body weight + 40 ml/hour.
3) Estimated fluid loss from surgical trauma: 4 - 6 mL/kg/hr. (liposuction was considered as a moderate surgical trauma) [5] .
In 1996, Trott et al. suggested guidelines for intraoperative fluid resuscitation. Patients having less than 4000 cc of lipoaspirate removed received maintenance fluid only, whereas those having more than 4000 cc of lipoaspirate removed received maintenance plus 0.25 cc of intravenous fluid for each milliliter aspirated over 4000 cc [1] .
To limit the degree of fluid overloading and possibility of pulmonary edema, Rohrich et al. modified the replacement fluid delivery at 0.25 cc of intravenous fluid for each milliliter aspirated over 5000 cc [2] .
Although blood loss in super wet liposuction is supposed to be 1% of the aspirate [6] , it is possible to exceed that percentage in some occasions e.g. technical issues, coagulopathy, etc. I recommend replacing the estimated blood loss with colloids in 1:1 ratio [7] , unless one of the blood transfusion indications is met.
As a fast review of blood transfusion indications, World Health Organization (WHO) defined them, in adults, as one of the following:
1) Perioperative transfusion: 8 g/dL for patient undergoing major surgery or experiencing GIT bleeding.
2) Acute blood loss: 30% of volume of blood.
considering that One unit of whole blood/packed red blood cells can increase haemoglobin by 1g/dL in an adult or haematocrit by 3% (haemoglobin of unit must be >75%) [8] .
National Institute for Health and Care Excellence (NICE) guidelines mention that when using a restrictive red blood cell transfusion threshold, consider a threshold of 70 g/liter and a haemoglobin concentration target of 70 - 90 g/liter after transfusion.
Restrictive red blood cell transfusion thresholds are for patients who need red blood cell transfusions and who do not:
l have major haemorrhage or
l have acute coronary syndrome or
l need regular blood transfusions for chronic anaemia [9] .
In literature, several methods of estimating haemoglobin can be found. Direct cyanmethaemoglobin method has been the gold standard for haemoglobin estimation but other methods like haemoglobin color scale, Sahli technique, Lovibond-Drabkin technique, Tallquist technique, copper-sulfate method, HemoCue and automated haematology analyzers are also available [10] .
In my opinion, two points had to be considered before choosing the haemoglobin estimation method:
1) The method should be manual, simple, fast without need for power supply.
2) The method should be able to detect very low concentrations of haemoglobin as we are trying to estimate the fraction/percentage of blood in a fluid not to estimate haemoglobin concentration in a proper blood sample.
For both of the considerations above, digital devices are not the best choice for the task. I chose Tallquist haemoglobin scale as a method (Figure 1).
The use of the Tallquist method in assessing anemia is of, relatively, high validity and diagnostic accuracy. Tallquist method should be an effective method to detect mild to moderate anemia in a reliable manner comparable to other standard methods such as the haematocrit and haemoglobin cyanide methods [12] .
2. Methods
1) After finishing liposuction, super wet in our case, the aspirated fluid volume (VF) is to be calculated, 400 cc in our example here (Figure 2).
2) Take a drop of the aspirated fluid and apply it on one filter paper, comes with Tallquist kit, wait till glistening disappears and compare it, before it completely dries, with the different color grades on the scale. The closest in our example was 4.7 g/dl (fluid haemoglobin concentration) (HbF) (Figure 3). Percentages on the scale indicate the ratio of the sample haemoglobin to a standardized sample of 15.6 g/dl haemoglobin. Do not use percentages in calculations not to get mixed with Hematocrit values.
3) Go back to the patient’s preoperative investigations and get the haemoglobin value (HbP) (Table 1) (13.6 g/dl in our case).
![]()
Figure 1. Tallquist haemoglobin scale [11] .
![]()
Figure 2. The aspirated fluid volume (VF) (400 cc in our example).
![]()
Figure 3. Take a drop of the aspirated fluid and apply it on one filter paper, comes with Tallquist kit, wait till glistening disappears and compare it, before it completely dries, with the different color grades on the scale. The closest in our example was 4.7 g/dl (HbF).
![]()
Table 1. Example patient’s preoperative investigations: Haemoglobin concentration (HbP).
4) Calculate the volume of intraoperative blood loss (VL) through applying the classic concentration/volume formula (C1V1 = C2V2)
,
and as a result,
3. Results
Tallquist Haemoglobin Scale can be considered as a valid method for proper estimation of intraoperative blood loss in liposuction cases using a mathematical formula that considers total fluid loss, patient’s preoperative haemoglobin and the reading from Tallquist kit, the thing that will lead to correct fluid resuscitation and fewer complications.
4. Discussion and Conclusion
Proper estimation of intraoperative blood loss will lead to fewer mistakes in fluid resuscitation, using crystalloids, colloids or blood, and protecting patients from under or over fluid balance correction. Application of the mentioned method can be expanded to be used in other surgeries with further blood loss. Tallquist Haemoglobin Scale can be considered as a valid method for proper estimation of intraoperative blood loss in liposuction cases. A classic mathematical formula that addresses volume and concentration of both pure patient’s blood and the aspirated fluid can be applied to detect the approximate intraoperative blood loss. Blood loss from the postoperative oozing should be considered as a next target for analysis.
Data Availability
The author confirms that the data supporting the findings of this study are available within the article.