K. N. Shivakumar, G. Swaminathan and M. Sharpe, “Carbon/Vinyl Ester Composites for Enhanced Performance in Marine Applications,” Journal of Reinforced Plastics and Composites, Vol. 25, No. 10, 2006, pp. 1101-1116. doi:10.1177/0731684406065194

has been cited by the following article:

• TITLE: Investigations on Mechanical and Tribological Behaviour of Particulate Filled Glass Fabric Reinforced Epoxy Composites

  AUTHORS: Bhadrabasol Revappa Raju, Bheemappa Suresha, Ragera Parameshwarappa Swamy, Bannangadi Swamy Gowda Kanthraju

  KEYWORDS: Al2O3 Filled G-E; Mechanical Properties; Two-Body Abrasive Wear; Scanning Electron Microscopy

  JOURNAL NAME: Journal of Minerals and Materials Characterization and Engineering, Vol.1 No.4, July 23, 2013

  ABSTRACT: The aim of the research article is to study the mechanical and two-body abrasive wear behaviour of alumina (Al2O3) filled glass fabric reinforced epoxy (G-E) composites. Alumina filled G-E composites containing 0, 5, 7.5 and 10 wt% were prepared using the hand lay-up technique followed by compression molding. The mechanical properties such as tensile strength, hardness and tensile modulus were investigated in accordance with ASTM standards. Two-body abrasive wear studies were carried out using a pin-on-disc wear tester under multi-pass condition against the water proof silicon carbide abrasive paper. From the experimental investigation, it was found that the presence ofAl2O3 filler improved the tensile strength and tensile modulus of the G-E composite. Inclusion of Al2O3 filler reduced the specific wear rate of G-E composite. The results show that in abrasion mode, as the filler loading increases the wear volume decreases and increased with increasing abrading distance. The excellent wear resistance was obtained for Al2O3 filled G-E composites. Furthermore, 10 wt% filler loading gave a very less wear loss. Finally, the scanning electron microscopic observations on the wear mechanisms Al2O3 filled G-E composites was discussed.