Effect of Land Management on Soil Hydraulic Conductivity in Gidan Kwano, Niger State, Nigeria ()
1. Introduction
The hydraulic conductivity of soil is an essential hydraulic property frequently used in hydrological modelling and water flow related studies in soils, such as irrigation and drainage system design and infiltration modelling; it is also a critical parameter for the monitoring of soil and water management (Tayfun, 2005). Knowledge of the rate of water permeability through various soil types is essential for determining the kind of plants to be grown, spacing, yield, managing soil-water systems and erosion control. Many methods have been developed over time for field and laboratory measurement for hydraulic conductivity. Unfortunately, these methods often yield substantially different results, as hydraulic conductivity is extremely sensitive to sample size, flow geometry and soil characteristics (Sarki, Mirjat, Asghar, Shafi, Kori, & Qureshi, 2014). Research has shown that regardless of the land management practices, a small portion of soil can be transported by a large part of water flow, indicating that the spatial hydraulic characteristics of soils are highly variable (Ibrahim & Aliyu, 2016). Knowledge of variability of soil physical properties can assist in defining the best strategies for sustainable soil management through the provision of vital information for estimating soil susceptibility to erosion, hydrological modelling and efficient planning of irrigation projects (Bagarello & Sgroi, 2004).
Several studies have been conducted on soil hydraulic properties about tillage, and the results were contradictory. Depending on cultivation history, climate zone, and soil management practices, saturated and unsaturated hydraulic conductivity under no-till or minimum tillage can be higher or lower (Miller, Sweetland, Larney, & Volkmar, 1998) than that under continuously tilled treatments, or not significantly different from that under continuously cultivated procedures (Bodhinayake, 2003). Change in land use from natural forest to crop cultivation modified the hydraulic properties of the surface soil resulting in an increased runoff/infiltration ratio (Leduc, Favreau, & Schroeter, 2001). Land use change is a complex process shaped by human activity affected by ecological, economic, and social drivers, and capable of influencing a wide range of environmental and economic conditions (MacDonald, Crabtree, Wiesinger, Dax, Stamou, & Fleury, 2000).
Understanding soil hydraulic conductivity is also essential for sound land management. Therefore, there is no single value that represents soil hydraulic conductivity because it varies in a wide range of circumstances and for all soil types and some of the specific problems that instigate the need of this kind of study which may be due to lack of suitability of the soil hydraulic conductivity and their acceptability in the study locations. Information relating to the hydraulic conductivity of the studied sites is a shortage.
This study is aimed at determining the hydraulic conductivity of soil under different land management practices and compare various results obtained from the study areas.
2. Methodology
2.1. Study Area
The host community of Federal University of Technology Minna Gidan Kwano is located along Minna-Bida road and is approximately 12 km from the state capital, Minna. Gidan Kwano lies between Latitudes 9˚31'N and Longitudes 6˚26'E with an estimated land mass of about eighteen thousand nine hundred hectares (10,000 ha). Teak plantation and Gmelina land is at latitudes and longitudes 9˚31'1''N, 6˚27'30''E and 9˚30'55''N, 6˚27'28''E respectively while Grassland and Maize cultivated land is at 9˚31'55''N, 6˚27'23''E, 9˚31'55''N, 6˚27'39''E respectively. The site is bounded Northwards by the Western rail line from Lagos to the northern part of the country and the eastern side by the Minna–Bida Road and to the North-West by the Dagga hill and river Dagga (Musa, Adewumi, & Ohu, 2012). Niger State is located in southern guinea savannah forest zone of Nigeria. It is known to have two distinctive seasons of wet and dry. The wet season starts mainly from the month of April and ends during the month of October of the same year with a precipitation of 25.4 mm, maximum and minimum temperature of 39˚C and 22˚C. The wind speed of the study area is 10 km/h while the average relative humidity is 60% (Musa, Akpoebidimiyen, Adewumi, Eze, Adesiji, & Gupa, 2020).
Four locations were selected to perform the experiment, which includes forest sites (Teak and Gmelina plantations), grassland (fallow) and maize cultivated land. Measurement of soil hydraulic conductivity was determined at four depths of 0 - 15 cm, 15 - 25 cm, 25 - 50 cm and 50 - 75 cm for each of the study locations.
2.2. Laboratory Analysis
Particle size analyses were determined by the hydrometer method according to the procedure of Gee & Or (2002) using sodium hexametaphosphate (Calgon) as a dispersant. Soil bulk densities were determined using the core method described by Fasinmirin & Adesigbin (2011). Soil samples were taken from soil core at depths 0 - 15 cm, 15 - 25 cm, 25 - 50 cm and 50 - 75 cm on each location of the land use using ring cylinders with height 5.1 cm and diameter 5 cm (Gabriels & Cornelis, 2008). Porosity was determined for each sample collected from the study area (Knutsson & Morfeldt, 2002). The porosity of the soil was calculated from bulk density, and particle density was assumed as 2.65 mg/m3 (Suzuki, Ranert, & Reichert. 2004). The hydraulic conductivity of soil was carried out according to the guideline of Akanegbu (2013).
2.3. Statistical Analysis
A statistical test was carried out to compare the various results obtained from the different land management practices for the study areas using SPSS and tests are conducted at a significance level of 0.05. For each of the location or different land management practices, the mean and standard deviation were calculated. A statistical test was conducted to check if each of the locations is significantly different. Marginal means of hydraulic conductivity, bulk density and porosity were used to compare the land use through multiple comparisons.
3. Results and Discussion
3.1. Soil Aggregate
The soil aggregate for the various study locations was determined and the result is presented in Table 1. It was observed that there was a gradual increment of the sand particle for 0 - 15 cm depth to a 50 - 75 cm depth which could be as a result of the decaying plant properties as this is within the root zone of crops.
Sandy soil is the most predominant soil in the study areas, and these are easily detached but hard to transport while the clayey soil is hard to separate but easily carried if finally separated. This reveals that the actual percentage of sand in any soil sample determines to a great extent the saturated hydraulic conductivity of that particular soil (Odumeke, 2014).
Table 1 presents the result of particle size composition of the collected soil samples. Teak plantation land shows a little variation in the percentages of sand,
Table 1. Soil textural classification of the forest land, Grassland and Maize cultivated land.
silt, and clay among the collected soil samples. According to the USDA classification system (Pachepsky & Park, 2015), the soil samples collected at the 0 - 15 cm, 25 - 50 cm depth of teak plantation land are predominantly Sandy clay loam while those of 15 - 25 cm and 50 - 75 cm depths are sandy clay and sandy loam. The highest value of sand is 68% at depth 50 - 75 cm it also has the lowest percentage of clay at the same depth of 50 - 75 cm and this is in line with research work on manure teak plantation by Fernández-Moya, Alvarado, Forsythe, & Marchamalo-Sacristán (2013). Table 1 shows that the gmalina plantation at depth 0 - 15 cm and 25 - 50 cm there is the same percentage of sand content which was also found in the studying of Fernández-Moya, Alvarado, Forsythe, & Marchamalo-Sacristán (2013). From the results obtained from grassland, it shows that sand contents have the highest value of 65% of sand at depth 0 - 15 cm and it has the lowest value of silt content as 15% in the study area of grass plantation. At depth 25 - 50 cm and 50 - 75 cm of grassland, the clay content remains the same. The results obtained from maize cultivated land shows that at depth 0 - 15 cm, 15 - 25 cm, and 25 - 50 the soil samples collected are predominantly sandy loam while that of depth 50 - 75 cm are sandy clay loam. The results obtained from soil textural classification throughout the land use mostly had a high percentage of sand particles. This high percentage of sand particles in this study area is similar to the works of Olorunfemi & Fasinmirin (2012). They recorded a high rate of sand particles throughout their study but the values obtained from their study were observed to be lower when compared with values from this study location. This high percentage was associated with their study area, which is in a forest zone where they experience a high amount of rainfall compared to this study location.
3.2. Statistical Analysis
Table 2 shows that soil bulk density value for teak plantation land was observed to be highest at depth 50 - 75 cm with little porosity of 22.96% which means the soil is too compacted and there is no record of soil hydraulic conductivity at the depth. Also, the lowest soil bulk density is at the surface i.e. depth 0 - 15 cm which is almost in line with Ajibola, Oguntunde, & Lawal (2018) and it has the highest hydraulic conductivity at the same depth. It was also observed that soil hydraulic conductivity decreases from the surface to the bottom i.e. from 0 - 15 cm to 50 - 75 cm. These values from teak plantation site in the table were much lower than those found by Rubio iEsteve (2006).
Gmelina plantation shows that soil bulk density increases from the surface to the bottom, i.e. from 0 - 15 cm to 50 - 75 cm. This is an indication that the soil is compacted down the soil profile for the study area. At 0 - 15 and 15 - 25 cm depth, the bulk density is almost the same with a recorded porosity of 42.26% and 41.87% respectively. This is virtually in line with Ajibola, Oguntunde, & Lawal (2018). The bulk density value obtained practically the same with one found by Uloma, Oyekachi, Torti, & Amos (2013). The grassland in Table 2 shows that the bulk density at 50 - 75 cm depth was 1.50 g∙cm−3 and is in line with a research work carried out by Uloma, Oyekachi, Torti, & Amos (2013). The result obtained from the grassland show some variation down the profile and these changes down the pattern is also in line with the work of Rubio iEsteve (2006) due to these variations of soil bulk density, it can state that soil bulk density is one of the significant soil property that affects soil hydraulic conductivity. Soil hydraulic conductivity at the 0 - 15 cm record the highest value due to low soil bulk density at the profile. The results from maize cultivated land in Table 2 indicate that the soil bulk density at 15 - 25 cm and 25 - 50 cm is same and the soil hydraulic conductivity at that depth varies by a small value. At depth 50 - 75 cm the soil hydraulic conductivity was lowest this could be as a result of high bulk density at the region. The highest amount of soil hydraulic conductivity from maize cultivated land in Table 2 was recorded at 0 - 15 cm depth. It is important to note that the physical properties of soil considered for this study are sand, silt and clay.
The saturated hydraulic conductivity varied at different locations. This confirms spatial variation of hydraulic conductivity as reported by other researchers (Rubio iEsteve, 2006). This variation was also further established by the statistical difference shown by other properties of soil determined which include porosity and bulk density. It was also noted that locations with the same soil textural class had different values of soil hydraulic conductivity. This is in line with the report of Ritzema (2006) that soils of same texture may have different soil hydraulic conductivity values due to differences in structure.
The subjected result to statistical analysis test in Table 3 shows that the hydraulic conductivity, bulk density and porosity of teak plantation site shows that
Table 2. Selected physical properties of the various study locations with their mean and deviation.
Where ρb = soil bulk density, P = porosity, Ksat = soil hydraulic conductivity.
Table 3. Comparative levels of significance of the various physical properties for the different study location.
* = The mean difference is significant at the 0.05 level, ns = the mean difference not significant at the 0.05 level and Where TP = Teak plantation site, GP = Gmelina plantation site, GS = Grass site, MS = cultivated land.
there is no significant difference between the teak plantation site and gmelina plantation site at 0.05 level. Though, there is a significant difference between teak plantation site and (grass, maize site), which means that bulk density, porosity and hydraulic conductivity does not affect the teak plantation and gmelina plantation site. Table 3 also shows that there is no significant difference (<0.05) between grass and maize cultivated land for bulk density and porosity but has a significant difference in teak and gmelina plantation site.
4. Conclusion
The results obtained have shown that saturated hydraulic conductivity varied at different locations. This variation was also further confirmed by the statistical difference shown by other properties of soil determined which include porosity and bulk density. It was also noted that locations with the same soil textural class had different values of soil hydraulic conductivity.
The study further reveals the significant differences in the soil of four land uses in Gidan Kwano, Minna Nigeria. The soil hydraulic conductivity is strongly compared to bulk density and porosity. The soil in forest zone (Teak plantation and Gmalina plantation) had a significantly high bulk density as compared to the low bulk density in the grass, maize, beans and yam sites. However, soil hydraulic conductivity was significantly high in the grass site or soil. Soil hydraulic conductivity is highly dependent on soil texture, soil bulk density and porosity. Results show that soil bulk density and porosity, affect soil hydraulic conductivity of soils of the study areas. Results obtained from the different land use serve as Knowledge of variability of soil that can assist in defining the best strategies for sustainable soil management through the provision of vital information for estimating soil susceptibility to erosion, hydrological modelling and efficient planning of irrigation projects. Finally, the results of the experiment revealed that soil hydraulic conductivity varies considerably among land uses. Saturated hydraulic conductivity was higher in grasslands than in other land use. Improvement on this study could be made through the expansion of the area of studied and increasing the number of samples and measurements since soil is highly heterogeneous and tends to vary from point to point even at the same layer.