Author(s)

Tobias Bensel¹, Jens J. Bock², Lisa Zumpe¹, Sonia Mansour³, Nadine Blümel¹, Julia Seeliger⁴, Arne F. Boeckler¹

¹Department of Prosthodontics, University of Halle, Halle, Germany.
²Private Orthodontic Practice, Fulda, Germany.
³Department of Prosthodontics, Gerodontology and Craniomandibular Disorders, Charité-University Medicine Berlin, Berlin, Germany.
⁴Department of Orthodontics, Technical University Dresden, Dresden, Germany.

Objective: Infection control protocols dictate the disinfection of dentures. There are no products available which are designed for the specific use of disinfecting dentures. The objective of this study was to investigate the impact of chemical disinfectants on elastic modulus, flexural strength and color stability of denture base resins. Methods: 256 specimens from four acrylic denture base resins were manufactured. Two cold-curing denture base resins: PalaXpress (Heraeus Kulzer, Hanau, Germany), Futura Gen (Schuetz Dental, Roßbach, Germany) and two heat-curing denture base resins: Paladon 65 (Heraeus Kulzer, Hanau, Germany), FuturAcryl 2000 (Schuetz Dental, Roßbach, Germany) were used. Three chemical disinfecting agents were tested: Impresept, D050 Instru-Gen, Stammopur DR. Specimens were stored in distilled water and in chemical disinfecting agents. They were divided randomly into groups. E-Modulus and flexural strength were measured using the three-point bending test. Color changes (ΔE) were determined spectrophotometrically. Results: The disinfection agents showed no significant influence on the E-modulus compared to distilled water (Acrylic vs. distilled water from (Futura Gen) 2688.80 ± 230.78 vs. 2766.60 ± 91.22 MPa to (PalaXpress) 3004.20 ± 26.40 vs. 2851.00 ± 95.23 MPa). Flexural strength after storage in distilled water and disinfection did not differ significantly (Acrylic vs. distilled water from (Paladon65) 27.28 ± 1.30 vs. 28.42 ± 0.84 N/mm², (p > 0.05) to (PalaXpress) 30.88 ± 0.25 vs. 29.68 ± 0.79 N/mm², p < 0.001). Disinfection caused a significant color change with Impresept of Paladon 65 (p ≤ 0.001), FuturaAcryl 2000 with Stammopur DR and D 050 Instru-Gen (p ≤ 0.001). Conclusions: The investigated disinfection agents did not influence elastic modulus and flexural strength of denture base resins negatively. ΔE-values were in a range of 1 to 2. Thus, the detected color changes may be marginal. Clinical relevance: Single use disinfections are feasible for acrylic dentures regarding to elastic modulus and flexural strength.

Cross Infection, Chemical Disinfectants, Denture Base Resins, Material Characteristics, Disinfection

Bensel, T. , Bock, J. , Zumpe, L. , Mansour, S. , Blümel, N. , Seeliger, J. and Boeckler, A. (2018) Effect of Disinfectants on Elastic Modulus, Flexural Strength and Color Stability of Denture Base Resins. Open Journal of Stomatology, 8, 135-148. doi: 10.4236/ojst.2018.84013.