ABSTRACT

Sinapinic acid is a widespread compound in vegetable material and is as such common in the human diet. Recently it has drawn attention because of its biological activities. Sinapinic acid can be synthesized from syringaldehyde via the Knoevenagel- Doebner condensation. However this reaction is limited by the formation of 4-vi- nylsyringol after a second decarboxylation. To gain more detailed information about this reaction and to improve control over the formation of sinapinic acid, the concentration time history of syringaldehyde and the reaction products of this reaction have been monitored over time at different reaction temperatures. The formation of 4-vinylsyringol was found to be inhibited by performing the reaction at temperature below 80˚C. This allows the reaction to be optimized for the production of sinapinic acid, with an optimal yield of 78% after 2.5 hours at 70˚C.

Keywords:

Ligno-Phytochemicals, Sinapinic Acid, Knoevenagel-Doebner Condensation, 4-Vinylsyringol

1. Introduction

In the last decade, there has been increasing interest in the effective use of lignocellulosic materials. Research that focuses on the recovery and/or the synthesis of chemicals from biomass is a prerequisite to realize a sustainable chemical industry within a forward-looking bio-based economy. Large-scale processes are being developed that use all components in wood, i.e. cellulose, hemicellulose and lignin. In these multi-step multi-product bio-refinery facilities, lignin could serve as a bio-based source of 4-hy- droxybenzaldehydes [1] .

The Knoevenagel-Doebner reaction has always been an important and reliable method for the formation of carbon-carbon bonds and is frequently used in industry [2] . 4-Hydroxybenzaldehydes can react with malonic acid in a Knoevenagel-Doebner reaction [3] to give the corresponding α, β-unsaturated carboxylic acids known as hydroxycinnamic acids. In nature, hydroxycinnamic acids can be found in the plant kingdom as secondary metabolites. There are three common members of these so-called ligno-phytochemicals of which ferulic acid has been studied extensively, primarily due to its anti-oxidant properties [4] . Ferulic acid is therefore used as a natural preservative in foods, beverages, and cosmetics.

Aldabalde et al. [5] and Simpson et al. [6] proposed a mechanism for the Knoevenagel- Doebner condensation of aromatic aldehydes and malonic acid using pyridine and piperidine as organocatalysts. The mechanism was illustrated by the conversion of vanillin into ferulic acid. During the reaction 2-methoxy-4-vinylphenol was observed as a second product following an extra decarboxylation step.

Sinapinic acid is another member of the hydroxycinnamic acid family [7] . Its effectiveness as anti-oxidant is considered to be superior over that of ferulic acid [8] . Moreover sinapinic acid shows anti-microbial, anti-inflammatory, anti-cancer and anti-an- xiety activities. In this study, the transformation of syringaldehyde (1) to sinapinic acid (2) with the Knoevenagel-Doebner reaction was performed in more detail. The formation of the corresponding vinylphenol, 4-vinylsyringol (3) can be confirmed, but this formation reaction is temperature dependent.

2. Materials and Methods

2.1. Materials

The reactant syringaldehyde (1), and all other chemicals were purchased at 99% purity from Sigma-Aldrich and were used as received without further purification. DMSO-d₆ was purchased from Cambridge Isotope with 99 atom% D.

2.2. Methods

Instrumentation: ¹H-NMR spectroscopy measurements were performed on an Agilent 400-MHz NMR system in DMSO-d₆. Data was acquired using VnmrJ 3 software. Chemical shifts are reported in ppm relative to tetramethylsilane (TMS).

HPLC analysis was carried out using a Liquid Chromatographic system (Agilent 1100 series) equipped with a diode array detector (Agilent 1200 series) and an autosampler injector with a 20 µL loop (Agilent 1100 serie G1316A). The system was equipped with a Luna 5 µm C18 column (250 mm × 4.6 mm) using acetic acid:wa- ter:methanol (0.01:50:50, v/v/v) as a mobile phase. The flow rate was 1.0 mL/min at a temperature of 20˚C. The Agilent Chem Station Software was used for data analysis. The quantitative determination of components in the reaction mixtures was carried out by the external standard method and based on peak areas.

LC-MS analysis was performed using a Liquid Chromatographic system (Agilent 1200 series) equipped with a Luna 3 µm C18 column (250 × 2.0 mm) and an ion trap (Agilent 6300 series).

2.3. Synthetic Procedure

Protocol for Knoevenagel-Doebner condensation: Malonic acid (1.0 g, 10 mmol) was dissolved in pyridine (3.0 mL, 37 mmol). Syringaldehyde (1, 0.90 g, 5 mmol) and piperidine (0.20 mL, 2 mmol) were subsequently added. The reaction was heated to the desired temperature and 50.0 µL samples were taken for reversed phase HPLC analysis. The samples were immediately diluted in 7.5 mL methanol, filtered and analysed using the method described above. The calculated percentage of peak area of the component of interest is in relation to the total area of peaks.

After 3 hours, the reaction was stopped and pyridine was removed in vacuo. The residue was dissolved in a small amount of a saturated aqueous NaHCO₃-solution and acidified to a pH of 2 with 6 M HCl. The resulting precipitate was separated by filtration and washed with water. After recrystallization with a solution of water-ethanol (v/v) (3:1), the crystals were separated by filtration and dried in a nitrogen atmosphere. 4-Vinylsyringol, was purified with column chromatography with ethyl acetate as eluent.

2.4. Products

The structures of syringaldehyde (1), sinapinic acid (2) were confirmed by ¹H-NMR, mass spectral data and by comparison with authentic samples available commercially. The structure of 4-vinylsyringol (3) was elucidated with LC/MS and, after purification with column chromatography, with ¹H-NMR (see representative examples in Supporting Information).

(E)-3-(4-hydroxy-3,5-dimethoxyphenyl)-2-propenoic acid (sinapinic acid, 2) (C₁₁H₁₂O₅, M = 224.21 g/mol) isolated as a white powder.

¹H-NMR (400 MHz, DMSO) δ (ppm) 12.10 (s, 1H), 8.87 (s, 1H), 7.47 (d, 1H), 6.96 (s, 2H), 6.39 (d, 1H), 3.78 (s, 6H). Mass spectrum recorded in negative ion mode, [M-H]⁻ m/z 222.8.

2,5-dimethoxy-4-vinylphenol (4-vinylsyringol, 3) (C₁₀H₁₂O₃, M = 180.20 g/mol) isolated as a brown liquid.

¹H-NMR (400 MHz, DMSO) δ (ppm) 6.72 (s, 2H), 6.63 (d, 1H), 5.61 (dd, 1H), 5.35 (s, 1H), 5.18 (dd, 1H), 3.85 (s, 6H). Mass spectrum recorded in negative ion mode, [M-H]⁻ m/z 178.8.

3. Results and Discussion

Aldabalde et al. [6] previously reported the conversion of vanillin to ferulic acid using the Knoevenagel-Doebner condensation. In their study, the reaction was performed in refluxing pyridine (115˚C) which served as solvent. Piperidine served as organocatalyst in both the carbon-carbon bond formation and the consecutive decarboxylations. The use of organocatalysts in organic synthesis is environmentally beneficial as stated by the Green Chemistry principles [9] . Under these conditions 2-methoxy-4-vinylphenol is the major product. For the Knoevenagel-Doebner condensation of syringaldehyde (1) and malonic acid towards sinapinic acid (2), we therefore decreased the temperature in the range of 50˚C to 90˚C to suppress the second decarboxylation which results in the vinylphenolic product (3) (Figure 1). We moreover used smaller amounts of the organocatalyst piperidine to further limit the environmental impact (0.2 eq instead of 0.4 eq used in the procedure of Aldabalde et al.).

From the results obtained, it is evident that the conversion rate of syringaldehyde is increased with temperature (Figure 2(a)). This is also the case with the formation of

sinapinic acid (2), but there seems to be an optimum between 70˚C and 80˚C (Figure 2(b)).

At temperatures above 70˚C the formation of 4-vinylsyringol (3) as a second product is observed (Figure 2(c)) following a second decarboxylation step. 4-Vinylsyringol and sinapinic acid can be separated by HPLC and their structures have been confirmed with ¹H-NMR and mass spectrometry. Furthermore, it should be noted that the formation of 4-vinylsyringol complicates the isolation of sinapinic acid using precipitation. Pure sinapinic acid forms a free flowing powder, while a 4-vinylsyringol contamination changes the morphology of the product into an oily, sticky material. The optimal conversion for the production of sinapinic acid from syringaldehyde was 78% after 2.5 hours at 70˚C.

4. Conclusion

This study supports the mechanism for the Knoevenagel-Doebner condensation between syringaldehyde and malonic acid as proposed by Aldabalde et al. Additionally, the formation of the vinylphenolic product via a second decarboxylation step was found to be inhibited by performing the reaction at a temperature below 80˚C. This allows the Knoevenagel-Doebner reaction to be optimized for the production of sinapinic acid. The optimal conversion for sinapinic acid was 78% after 2.5 hours at 70˚C. In the present protocol pyridine is only used as a solvent. Because of pyridines environmental impact it would be worthwhile to diminish or eliminate its use and investigate alternatives.

Acknowledgements

Funding of this work came from SIA RAAK and of the Dutch National Science Foundation (NWO). We thank Edward Knaven, Avans University of Applied Science, for expert help with the LC/MS measurements and Bart Noordover, Eindhoven University of Technology, for his guidance and advice.

Cite this paper

van Schijndel, J., Canalle, L.A., Smid, J. and Meuldijk, J. (2016) Conversion of Syringaldehyde to Sinapinic Acid through Knoevenagel-Doebner Condensation. Open Journal of Physical Chemistry, 6, 101-108. http://dx.doi.org/10.4236/ojpc.2016.64010

References

Supporting Information

Submit or recommend next manuscript to SCIRP and we will provide best service for you:

Accepting pre-submission inquiries through Email, Facebook, LinkedIn, Twitter, etc.

A wide selection of journals (inclusive of 9 subjects, more than 200 journals)

Providing 24-hour high-quality service

User-friendly online submission system

Fair and swift peer-review system

Efficient typesetting and proofreading procedure

Display of the result of downloads and visits, as well as the number of cited articles

Maximum dissemination of your research work

Submit your manuscript at: http://papersubmission.scirp.org/

Or contact ojpc@scirp.org