^{1}

^{*}

^{1}

^{1}

^{1}

Magnetotelluric surveys have been conducted in the Mintom area in order to evaluate the water infiltration potential of the Dja river in a limestone deposit estimated at about 350 million?m
^{3}
laying on a network of faults compromising the exploitation of this limestone deposit. The interpretation of these data shows that this network of faults is clearly highlighted as 2D/3D structures consolidated showing a low potential water infiltration through these structures. This result is confirmed by the absence of confined and induced aquifer along all the profiles. From this finding, we concluded that the exploitation of this deposit is not conditioned by the water infiltration from the Dja River.

An area of limestone deposit of about 350 million∙m^{3} which is potentially exploitable for 30 years laying on an area of 7 km^{2} was highlighted in Southern Cameroon in the northern margin of the Congo craton based on the satellite data, petrographic and geochemical studies. The finalization of this project is partly conditioned by the behavior of water seepage which can be primarily operated through the fault system [

For this reason, 19 magnetotelluric surveys were implemented in the flooded zone of the project to highlight in general the shallow structures of the area and in particular to assess water infiltration potential of river Dja through this fault system [

The Precambrian area in South Cameroon is made up of two geotectonic units: the Neoproterozoic mobile belt in the northern part that is represented by the Yaounde Group and the Ntem Complex in the southern part, which is the northwestern corner of the Congo craton (

The Ntem Unit is dominated by massive and banded plutonic rocks of the charnockite suite and by intrusive tonalites, trondhjemites and granodiorites. Some of these bodies were previously dated at ca. 2.9 Ga [

The area under study lies in the South-eastern domain of Cameroon, located in the Ntem Unit at Bi-Mintom (

The equipment used in this campaign is a resistivity-meter ECA 540, this resistivity-meter is composed of two identical selective measuring outlets, associated to an acquisition and calculation system that uses a micro-pro- cessor. The data sets were collected into two perpendicular directions (TE and TM).

Data acquisition is based on the magnetotelluric method principle [

In this work, measured impedance tensor will be obtained starting from Simms formula [

The confidence interval of impedance tensor will be estimated in a robust way by Jackknife variance estimation [

The resulting impedance tensor is given by:

Dimensional analysis parameters can be express by:

If the phase tensor is symmetric (β = 0) the principal values of the tensor are equal to its Eigen values. This situation occurs where the regional conductivity distribution is mirror symmetric, e.g. where the regional conductivity distribution is 1D or 2D. Where Φ is symmetric and has equal principal values, such as is the case if the conductivity distribution is uniform or 1D, the electric field will be linearly polarized if the magnetic field is linearly polarized. In the 2D case, the principal values will usually be distinct (i.e.

・ Profile “A”

According to this profile, values of

These results are in accordance with the existing geological data where a superficial limestone deposit equivalent to 3D structures has been highlighted [

Superficial variations (100 m) of

At “A3”, where

This fault system must be included in the network of faults characteristic of Mintom area where tectonic data have detected a concentration of lineaments in the Congo Craton.

・ Profile “B”

According to this profile,

These results also highlight the presence of 3D structures comparable to limestone deposit observed from satellite radiography and data field.

At “B4” in which non-zero values of

2D structures assimilated to faults are observed at “B4” and “B7”, these are probably part of the network fault presumed lineaments.

・ Profile “C”

Along this profile,

The observation of these 3D structures assimilated to limestone along 8km confirms the relevance of this limestone deposit.

Absence of 2D structures assimilated to faults shows that the network fault plans by lineaments is not locally distributed in the limestone deposit but is left in Mintom area.

The inversion data from Occam code was made following all stations simultaneously a profile for resistivity and phase following the TM and TE modes. For this, a graphic representation of resistivity profiles based on five-color range was emerged in the interpretation of data.

・ Profile “A”

A surface range (blue) of between 590 - 2100 W∙m is observable along this profile with a peak generally of around 100 m and picks up 150 m where superficial 3D structures have generally been highlighted except to “A2”.

A second line (green) between 2000 and 7700 W∙m is observable in the first all stations with deep roots to “A3” and a surface appearance at “A2”, it should be noted that 2D structures deep and superficial respectively, were highlighted in these stations (

The third range of resistivity (yellow) between 7700 and 28,000 W∙m is as the lower roof of the second range.

The fourth range of resistivity (red color), whose values are comprised between 28,000 and 100,000 W∙m shows no incrustation in the third range along the profile.

・ Profile “B”

To a range between 500 - 2100 W∙m is observed along this profile along a roof of around 150 meters deep in places, 3D structures can generally been highlighted by dimensional analysis except “B7”.

The second range between 2100 and 7700 W∙m is observable under the first except “B6” or it is surface with a deep root, deep 2D structures have been highlighted at this station (

The third range is between 7100 and 27,000 W×m and the fourth between 27,000 - 100,000 W∙m exhibit no incrustation in the third range along the profile.

・ Profile “C”

According to this profile a first range whose values vary between 470 - 1000 W∙m is observed at all stations or 3D structures were recorded.

A second range between 1000 - 2200 W∙m is observable without deep inlays but with near surface appearances “C2” and “C3” where 2D structures have been recorded in a few isolated depths.

The third and fourth resistivity ranges are respectively between 2200 - 4700 W∙m and between 4700 - 100,000 W∙m are stacked again without incrustation which bodes of the presence of 3D surface structure below which arise globally tabular structures (

After this plant cover the first range of resistivity ranges between 500 - 2000 W∙m broadly is comparable to consolidated calcareous structures as superficial 3D structures have been highlighted following all profiles. This result shows that the roof of the limestone structures varies between 100 and 150 m, an average of 100 meters is possible which confirms the deposit to 350 million∙m^{3} [

After the foregoing operation of the resistivity curves in the three profiles and information from the exploitation of geological wells [

The second range of resistivity globally between 2000 - 7000 W∙m with superficial and deep appearances and varying thickness is similar to Precambrian gneiss-granite structures characteristic of this study area [

The third range 7000 - 30,000 W∙m is similar to the structures of sin granites former tectonic characteristic thickness of the low area and when the granite base is represented by the fourth range between 30,000- 100,000 W∙m [

In view of the above, it appears that 2D structures comparable to the superficial and deep faults highlighted part of the network of faults developed along the Dja river with a NNW-SSE direction over 60 km [

The observation values of

The interpretation of magnetotelluric data has helped to highlight the medium calcareous thicknesses consolidated to about 100 m, this confirms a deposit estimated at about 350 million∙m^{3}, which are overall supplanted by a network of faults developed along the Dja river and witnesses an old tectonic activity.

However dimensional analysis Caldwell has found that these flaws are size 2D/3D and 2D inversion code from OCCAM found no superficial or deep anomaly similar to an aquifer through this fault system. These results show that the fault system is consolidated and its cemented matrix limits water infiltration, moreover the network fault plans by lineaments are not locally distributed in the limestone deposit but are left in Mintom area.

The authors would like to thank the late Mr. Philippe NKOUNGOU MBA, Mr. Jeannot NOUCK, Mr. Raphael ASSAMBA and Mrs. Julienne Ngo MATIP for theirs general comments and suggestions. They also want to thank Mrs. Esther BINDANG MBOT for the financial support.

Harlin L. EkoroNkoungou,Daniel H.Gouet,Philippe NjandjockNouck,Eliézer ManguelleDicoum,11,11, (2015) Water Infiltration Study from Magnetotelluric Data in the Limestone Fault Network of Mintom (South Cameroon). International Journal of Geosciences,06,1007-1017. doi: 10.4236/ijg.2015.69080