Calcium hydroxide nanoparticles in aqueous suspensions (also called nanolime) were successfully employed in Cultural Heritage conservation thanks to the ability of favoring readhesion of the pictorial layer on original carbonatic substrates or allowing to a better superficial cohesion and protection of treated stones. In this work, we have synthesized nanolime particles in aqueous suspension by two different methods. The produced particles were characterized in the laboratory, in terms of structural and morphological features, by means of X-Ray diffraction powder (XRD) and by transmission electron microscopy (TEM), respectively. Nanoparticles were crystalline, regularly shaped, hexagonally plated and with side dimensions generally ranging from 300 nm to 30 nm or less. Crystal structure of nanolime particles directly in the aqueous suspension, has been also analyzed by synchrotron diffraction from X-ray synchrotron radiation (SR-XRD); data have been analyzed by means of the Rietveld method and we have investigated the structure of Ca(OH)2 particles in suspension in terms of cell parameters, atomic coordinates, bond lengths and angles.
Calcium hydroxide (Ca(OH)2), has been largely employed thanks to the well-known carbonation reaction and to the characteristics of the calcium carbonate (CaCO3) obtained. The low solubility and the compatibility between the latter compound and material substrates offer a favorable use in many lime-based superficial conservative treatments [
The synthesis allows to obtain Ca(OH)2 nanoparticles directly in suspension, as they are used in the applications. It is fundamental to verify that the obtained nanoparticles, very reactive thanks to their dimensions, don’t show the carbonatation process inside the suspension, but only during the applicative use, when the solvent is completely evaporated.
The aim of this work has been to synthesize Ca(OH)2 nanoparticles by different methods and to compare the obtained results, in terms of structural features of the particles both in the aqueous suspension and after the solvent was completely evaporated. In particular, two nanolime synthesis methods, reported in our previous works [2,6], have been followed. According to method (A), synthesis has been carried out by adding (drop by drop) an aqueous NaOH solution into a CaCl2 one, maintained at 90˚C. According to method (B), a surfactant agent (Triton X-100) was previously added to the two initial aqueous solutions that were later mixed simultaneously, at the fixed temperature of 90˚C. The method (B) allows to obtain Ca(OH)2 nanoparticles easily and drastically reducing the time of synthesis. In fact, especially if tenths of grams were prepared, we passed from several hours for the drop by drop method to few minutes; this difference in time scales with the quantity of the preparation, allowing us to scale-up the nanolime production only when the method (B) is followed.
The morphology and particles size have been investigated by transmission electron microscopy (TEM).
We have investigated the phases formed after the synthesis procedure, by means of X-ray diffraction powder technique (XRD). The XRD diffraction is a powerful, non-destructive and useful technique that allow to quickly analyze unknown materials, in terms of crystallinity and phases identification, and to perform materials characterization in many scientific fields such as engineering, metallurgy, mineralogy, sciences, archeology, etc. The great advantages of this technique are: the simplicity in sample preparation, the rapidity of measurement, the ability to analyze mixed phases, the structure determination directly in laboratory. In particular, XRD technique can easily allow to investigate the reactivity, in terms of carbonatation process efficiency, of the produced calcium hydroxide nanoparticles. For this reason, we have considered different agglomeration conditions of the nanoparticles (that could strongly influence the carbonatation process) partially substituting water with 2-propanol, as disagglomerating agent [
We have also investigated the Ca(OH)2 nanoparticles crystalline structure directly in aqueous suspension by using synchrotron radiation at the European Synchrotron Radiation Facility (ESRF)-Grenoble, France. In fact, the high energy and high flux of this source allowed diffraction measurements in transmission of the particles inside the aqueous medium. X-ray synchrotron diffraction data have been analyzed by means of the Rietveld method and we have investigated the structure of Ca(OH)2 particles in suspension in terms of cell parameters, atomic coordinates, bond lengths and angles.
Calcium chloride dihydrate (CaCl2∙2H2O), sodium hydroxide (NaOH) and 2-propanol pro analysi products, supplied by Merck, have been used without further purification. In case of method B) polyoxyethylene (10) tertoctylphenyl ether, Triton X-100 (C14H22O(C2H4O)10), a high-purity, water-soluble, liquid, non-ionic surfactant, purchased from Fluka has been used too. Water has been purified by a Millipore Organex system (R ≥ 18 MΩ cm).
Method (A). We have prepared two different aqueous solutions of 100 ml, containing 0.3 mol/l of CaCl2∙2H2O and 0.6 mol/l of NaOH respectively. The NaOH alkaline solution (used as precipitator) has been added drop by drop into the CaCl2 solution (speed ≈ 4 ml/min, temperature of 90˚C). After about 24 hours two distinct phases have been observed, a limpid supernatant solution and a white precipitated phase; to remove the NaCl produced, several deionised water washings have been performed. Aqueous nanolime suspension (with a Ca(OH)2 concentration of 10 mg/ml) has been defined as sample A.
Method (B). (4.00 ± 0.02) g of Triton X-100 has been previously added to the initial aqueous solutions containing 0.3 mol/l of CaCl2×2H2O and 0.6 mol/l of NaOH respectively (each solution was 100ml in volume). These initial solutions have been then mixed together simultaneously, at the temperature of 90˚C. A suspension of 200ml of final volume has been obtained, characterized by a Ca(OH)2 concentration of 10 mg/ml (sample B). As in method (A), we have performed several deionised water washings to remove the NaCl produced and the surfactant too.
For both the methods, different residual water contents were considered preparing four samples, named A100, A75, A50, A25, B100, B75, B50, B25, respectively: the subscript represents the percentage of water content in each sample.
By TEM technique (Philips CM 100), the dried particles morphology of the samples under study have been analyzed; measurements have been performed on the samples dried under vacuum, following the common procedure.
As concerns XRD measurements (Philips X’Pert PW 1830), performed in our laboratory to determine the crystalline degree and the phases of the formed particles, the sample was prepared maintaining each aqueous suspension for 20’ in ultrasonic bath (US) and then depositing 0.2 ml of the suspension itself on a silica sample holder; measures were performed on dry sample, in laboratory conditions (T = 20˚C, relative humidity RH = 40%). Each experimental diffraction spectrum has been elaborated by a Profile Fit Software (Philips PROFIT v.1.0) and each crystalline phase has been attributed by JCPDS patterns; the ratio between the calcium carbonate peaks area and the spectrum total area has been assumed as the carbonatation process efficiency (yield).
Crystal structure of the nanolime particles directly in aqueous suspension has been investigated by SR-X ray measurements on GILDA (BM08) beamline at ESRF; the patterns were collected in Debye-Scherrer geometry on a 2D image plate detector. The experiment was performed at an incident beam wavelength of λ = 0.7277 Å and the sample-to-detector distance adjusted to obtain data within the 6˚ - 53˚ 2θ-angle range. Data were collected from 0.2 ml of aqueous suspension sealed within a cell with Kapton windows, mounted on a rotating sample holder in order to avoid deposition of the nanoparticles during the measurement, to make a good average of the structural characteristics of the particles in suspension and to improve statistics. Patterns of water alone and Triton X-100 have been also collected to consider their contribution to the background in aqueous Ca(OH)2 suspensions spectra. Data have been collected on a 2D image plate and integrated, after standard calibration and corrections, to obtain I(2θ) data, then analyzed by Rietveld method (FullProf package [
From TEM measurements, here we have reported some images taken as representative micrographs for each sample analyzed.
In particular, in
The results obtained by TEM images, could be explained considering that the surfactant can affect the nanolime formation. It could be supposed that, during the growth of the nanolime crystals, the molecular units of the surfactant stick on the surface of the crystals by weak forces; they gradually could form a film that prevents the growth of the formed crystals.
XRD spectra, in relation to the different water content in the nanolime suspension, have been reported in
From
(a)
(b)
80% (sample A75).
On the contrary, in sample B (where the surfactant is present), all the carbonatation yield values were probably higher due to the particles decreasing, as confirmed by TEM investigation (
Analysis of the SR-XRD data allows us to determine that the Ca(OH)2 nanoparticles don’t show the carbonatation process inside the suspension. Besides, we have determined the structural parameters of the Ca(OH)2 crystals in aqueous suspensions synthesized by the two different methods, in terms of cell parameters, atomic coordinates, interatomic distances and bond angles, DebyeWaller factors, preferred orientation of crystallites and average grain dimension. We have used the pseudo-Voigt profile function of Thompson, Cox and Hastings [
SR-X ray diffraction patterns for samples A and B, refined with Rietveld method, have been reported in
In
by the synthesis method.
Finally, by Rietveld analysis [
microcrystalline phases, in particular for the sample synthesized by the addition of surfactant.
The present work was focused on a new synthesis of Ca(OH)2 nanoparticles, in aqueous suspensions, by adding a surfactant agent in the initial reactants, so obtaining very small particles easily and reducing drastically the time needful for preparation. We have studied Ca(OH)2 nanoparticles, synthesized in our laboratory, in terms of structural and morphological features, by means of XRay diffraction powder (XRD) and by transmission electron microscopy (TEM). The Ca(OH)2 nanoparticles, studied also in terms of the carbonatation process by XRD, appeared crystalline, hexagonally plated and regularly shaped, with dimensions ranging from 300 nm to 30 nm or less.
By means of synchrotron radiation (SR-XRD) we have studied the structure of the Ca(OH)2 nanoparticles directly in aqueous suspension. From Rietveld refinement of SR-X ray diffraction data, we have found that the addition of surfactant during the synthesis tends to reduce the cell volumes of Ca(OH)2 particles in aqueous suspension.