H. K. T?nshoff and J. Winkler, “The Influence of Tool Coatings in Machining of Magnesium,” Surface and Coatings Technology, Vol. 94-95, No. 10, 1997, pp. 610- 616.

has been cited by the following article:

• TITLE: Surface Roughness Evaluation in Dry-Cutting of Magnesium Alloy by Air Pressure Coolant

  AUTHORS: Jeong-Du Kim, Keon-Beom Lee

  KEYWORDS: Machinability, Surface Roughness, Number of Inserts, Dry Milling, Air Pressure Coolant

  JOURNAL NAME: Engineering, Vol.2 No.10, November 29, 2010

  ABSTRACT: In this paper, a studying of surface roughness in dry milling with air pressure coolant of wrought magnesium alloy AZ31B will be carried out. The effects of air flow, feed-rate per tooth, cutting velocity and number of inserts in a cutting tool on surface roughness have been examined. Surface roughness increases with increasing feed-rate per tooth and increasing number of inserts in the cutting tool. However, it is nearly unchanged under a specific range of cutting velocity in the experiment and improved by the flow of air cooling.