S. Tripathi and G. Banerjee, “Synthesis and Mechanical Properties of Mullite from Beach sand Sillimanite Effect of TiO2,” European Journal Ceramic Society, Vol. 18, No. 14, 1998, pp. 2081-2087. doi10.1016/S0955-2219(98)00149-6 - References

Browse Menu >>

Browse Subjects >>

Computer Science & Communications

Earth & Environmental Sciences

Social Sciences & Humanities

Why Us? >>

- Open Access
- Peer-reviewed
- Rapid publication
- Lifetime hosting
- Free indexing service
- Free promotion service
- More citations
- Search engine friendly

Free SCIRP Newsletters>>

Add your e-mail address to receive free newsletters from SCIRP.

Contact Us >>

customer@scirp.org

+86 18163351462(WhatsApp)

1655362766

Paper Publishing WeChat

Book Publishing WeChat

(or Email:book@scirp.org)

Article citations
More>>

S. Tripathi and G. Banerjee, “Synthesis and Mechanical Properties of Mullite from Beach sand Sillimanite: Effect of TiO2,” European Journal Ceramic Society, Vol. 18, No. 14, 1998, pp. 2081-2087. doi:10.1016/S0955-2219(98)00149-6

has been cited by the following article:

TITLE: Value Addition to Red Sediment Placer Sillimanite Using Microwave Energy and in Depth Structural and Morphological Characterization of Mullite

AUTHORS: Satya Sai Srikant, Saroj Kumar Singh, Partha Sarathi Mukherjee, Raghupatruni Bhima Rao

KEYWORDS: Microwave Heat Energy; Sillimanite; Mullite; Value Addition

JOURNAL NAME: Journal of Minerals and Materials Characterization and Engineering, Vol.11 No.11, November 20, 2012

ABSTRACT: This paper deals with the effect of microwave energy for mullite formation from placer sillimanite. A mullite formation is seen when 60 % SiC and 5% binder are used with the composite charge material, i.e. sillimanite (60%) and Al2O3 (40%). The maximum temperature of the microwave sintering furnace achieved is 1355°C at 2450 W microwave power. Addition of 10 % binder to the same charge material with 60% SiC, the furnace temperature achieved is 1384°C at microwave power 1900 W. Mullite is formed within 25 minutes from the sillimanite, under the above experimental conditions. Whereas under the similar additive conditions, the mullite formed from sillimanite in conventional furnace heating, it took 3 hours at 1300°C. XRD data show the mullite phase for both the products obtained from microwave sintering furnace and conventional furnace. FESEM image analysis shows the mullite formations, SiC fibrous cluster and alumina needles in microwave treated sample. Thus microwave heat source is much more effective for value addition to red sediment placer sillimanite to form mullite in compare to conventional furnace.