SCIRP Mobile Website
Paper Submission

Why Us? >>

  • - Open Access
  • - Peer-reviewed
  • - Rapid publication
  • - Lifetime hosting
  • - Free indexing service
  • - Free promotion service
  • - More citations
  • - Search engine friendly

Free SCIRP Newsletters>>

Add your e-mail address to receive free newsletters from SCIRP.


Contact Us >>

WhatsApp  +86 18163351462(WhatsApp)
Paper Publishing WeChat
Book Publishing WeChat

Article citations


Y. Yand, C. G’Sell, J. Hiver and S. Bai, “Dynamic Mechanical Properties and Morphology of High-Density Polyethylene/CaCO3 Blends with and without an Impact Modifier,” Journal of Applied Polymer Science, Vol. 103, 2007, pp. 3907-3914.

has been cited by the following article:

  • TITLE: Effectiveness of Talc Filler on Thermal Resistance of Recycled PET Blends

    AUTHORS: Kazushi Yamada, Supaphorn Thumsorn

    KEYWORDS: Recycled PET; Injection Moldings; Talc; Heat Distortion Temperature

    JOURNAL NAME: Advances in Materials Physics and Chemistry, Vol.3 No.8, December 31, 2013

    ABSTRACT: In general, high mechanical properties such as higher impact strength and thermal resistance are required for injection molded applications. Recycled PET (RPET) is well known to exhibit brittle behavior in the presence of notches and indicated the low heat distortion temperature. Therefore, we tried to improve the toughness and thermal resistance properties of RPET by incorporating E-GMA, talc filler and engineering plastics as an impact modifier and talc to increase the rigidity and heat distortion temperature of RPET. As a result, these blends with E-GMA exhibited significantly higher stiffness and strength especially with increasing E-GMA content. In addition, these blends with talc filler indicated the high heat distortion temperature due to the increase of the crystalinity of RPET blends. Therefore, it was found that talc played an important role in enhancing the heat resistance of RPET.