On the Dynamics of Transition of a Classical System to Equilibrium State ()
1. Introduction
The problem of the transition of a physical system from a non-equilibrium state to a final permanent equilibrium state plays a central role in understanding the dynamics of the behavior of the system during this transition [1]- [8]. In such systems, energy dissipation or energy transfer is a crucial quantity for the system to be able to undergo a transition from non-equilibrium to final equilibrium state [9][10][11][12][13]. A well-known system which demonstrates the role and mechanisms of energy dissipation during its transition from a non-equilibrium to an equilibrium state is the two-capacitor problem which has been under investigation by many authors [14]- [21]. Classical systems, which involve energy dissipation in their transition from non-equilibrium to equilibrium state, have recently attracted much attention of many authors [22][23][24][25][26]. Students usually have difficulty in understanding the dynamics involved in such systems during their transition from non-equilibrium to equilibrium state [27]and some activities and models have been proposed to overcome some of their main difficulties [28][29]. A major difficulty for students arises when they deal with final equilibrium state for a spring-mass system. To be specific, we consider the following spring-mass system: A block of mass M, rests on a horizontal table, is attached to one end of a spring whose other end is fixed to a vertical fixed wall. The other side of the block is attached to a massless rope that passes over a frictionless pulley and another block of mass m is attached to the other end of the rope and hanged vertically off the table. The aim of this paper is to study and analyze the dynamics and the behavior of this system during its transition to final stable equilibrium state after the release of the hanged mass m. In this paper, we apply the Lagrangian method and solve Lagrange equations to determine the position of the hanged mass at any half-cycle n. Our results show the suitable n which is needed for the system to attain its final equilibrium state. It is also shown that one can get the total distance covered by the system. In addition, the dissipated energy in the process is analyzed and its relation to the energy stored in the spring is pointed out. It is remarkable to note that in the limit when the coefficient of friction goes to zero, our results show that the energy dissipated is exactly the same as the energy stored in the spring and so each is half the initial gravitational potential of the hanged mass.
2. Spring-Mass System and Equation of Motion
Our system consists of a spring (spring’s constant k), on a horizontal table with coefficient of kinetic friction
, which is fixed at one end and the other end is attached to a block of mass M which is connected to a massless rope that passes over a frictionless pulley fixed (but free to rotate) at the end of the table and another block of mass m attached to the rope and hanged off the table (see Figure 1 below).
Initially, the system is at rest and the zero reference is set at the position of m. After the system is released, the maximum downward distance,
covered by m occurs when it comes momentarily to rest and this can be determined by requiring that the work done by frictional force is equal to the change in the mechanical energy, with the result;
. (1)
This occurs when m reaches zero velocity and M reaches maximum displacement to the right. In the second step m returns up and M moves to left until the system gets to zero velocity after which M moves to right and m moves downward and the system repeats the motion with decreasing amplitude due to the work done by frictional force between M and the table. Finally the system comes to final stable equilibrium state and the final displacement
made by the system is determined by balance of forces with the result;
![]()
Figure 1. Two masses connected to a spring.
, (2)
which is exactly half x0. We must note that initially (just before the release) the system is in a non-equilibrium state and finally in an equilibrium state. The dynamics which controls the behavior of the system between these two states is undermined and the physics involved is not utilized. Our aim in this paper is to examine the behavior of the system during its transition between these two states. Specifically, we will find the position of m during any given half cycle n, its final position at the end of each half cycle and the number of half cycles made by the system before it comes to the final equilibrium state.
Let x be a generalized coordinate, the Lagrangian of the system is
, (3)
where x and
are the position and speed of m. The Lagrange’s equation of motion for the generalized coordinate x reads
, (4)
where Q is the frictional force between the surface and M and is given by
, (5)
with n is the number of half-cycle of the motion. For odd n, M is moving to the right so that the frictional force is negative, while for even n, M is moving to the left so that the frictional force is positive. Inserting Equations (4) and (5) into Equation (3) gives
, (6)
where
. Equation (6) is an inhomogenous first order differential equation, whose solution after applying the initial condition
for each half-cycle, is
. (7)
The constant
can be found as follows:
For the first half cycle,
, i.e.
, we have
so that equation (7)
gives
. For the second half cycle,
, i.e.
, we
require that the final position of m at end of the first half cycle equals the initial position at the beginning of the second half cycle, which means the
. This gives,
. In a similar way, for the nth
half cycle,
, we require the position of m at end of the (n − 1) half cycle equals to its position at the beginning of the nth half cycle, which means
. One might expect that
, (8)
d hence Equation (7) becomes
, (9)
which we prove by mathematical induction as follows: For
, we already derived
which upon its substitution into Equation (7) gives
. We assume Equation (9) is true for any n, and we need to show that it is true for
. For the
half cycle,
, we require that
. This means that, at
, the position of m at the end on the nth half cycle is equal to its position at the beginning of the
half cycle. Using Equations (7) and (9), we get
The above equation immediately yields, for both case n = odd and n = even,
, namely
, (10)
which, upon its substitution into Equation (7), gives us
. (11)
This is exactly
given in Equation (9) with
, and this completes the proof.
Equation (9) yields for n = odd, with
(12)
which gives the lowest position of m and the maximum right displacement of M when they come momentarily to rest at the end of the nth half-odd cycle. For n = even, Equation (9) yields,
, (13)
which gives the highest position of m and the maximum left displacement of M when they come momentarily to rest at the end of the nth half-even cycle.
3. The Final Equilibrium State
Now the question is where the system comes to equilibrium permanently? We claim that this occurs at a final position given by
. (14)
Using Equation (9) for
, Equation (14) gives,
, (15)
where the signs + (−) are for n = odd (even). The result given in Equation (15) is expected, since for the n = odd case the motion is from odd n to even (n + 1) which means that mass m is moving upward and M is moving to the to the left and thus the balancing of forces gives
which gives the result in Equation (15) with the plus sign. Similarly, for the n = even case, motion is from even n to odd (n + 1) which means that m is moving down and M is moving to the right and thus the balancing forces gives
which gives the result in Equation (15) with the negative sign.
It is interesting to find the value of n at which the system reaches its final equilibrium state. This could be found by equating
from Equation (9) with
for the two cases n = even and n = odd which is given by Equation (15). Straightforward calculations give, for both cases
(16)
To find the total distance covered by either m or M, one must notices that for the nth half-odd cycle m is moving down while for the nth half-even cycle it is moving up. Therefore, if we let N to be the integer part of Equation (16), we have for N = even,
(17)
The substitution of
for n = odd from Equation (12) and for n = even from Equation (13) we get
(18)
Substituting for
from Equation (15) with the negative sign, Equation (18) gives
. (19)
It is interesting to note that the substitution
enables us to write Equation (19) in terms of N or in terms of the original quantities as
. (20)
Similarly, the total distance for the case N = odd, we have
. (21)
Noting that the two sums are similar to those in Equation (17) but with
, so using this and substituting for
from Equation (15) with the positive sign, we get
, (22)
which upon using
, the above equation can be written in terms of N or in terms of the original quantities as
. (23)
This is exactly the same as the total distance given by Equation (20) for the even N case.
It is constructive to express the total distance
in terms of the final position
. For N = even, Equation (15) gives
, so that
. Substituting this in Equation (20) gives
. (24)
while for N = odd, Equation (15) gives
,so that
. Substituting this result into Equation (23) gives
(25)
4. Energy Considerations
Our result for the total distance covered by m or M can be checked from energy considerations. The gravitational potential energy of m is consumed by energy stored in the spring and a work done against friction between M and the surface. Namely,
(26)
Using Equation (15) for
, we get:
For N = even,
and using
, we recover our result given in Equation (24), namely
.
For N = odd, the substitution for
from Equation (15) into Equation (26),
we get
and using
, we recover our result given in Equation (24), namely,
.
It is interesting to determine the energy stored in the spring,
and the work done against friction
and compare them with the initial gravitational potential energy,
of the hanged mass m relative to its final position.
Using Equation (15) for
and Equation (20) for
, we get
(27)
(28)
(29)
(30)
From the above equations, one can immediately find,
, (31)
where the − (+) sign is for N = even (odd)
, (32)
where the + (−) sign is for N = even (odd).
It is constructive and interesting to consider the special case when the horizontal surface is frictionless (
): Equations (27)-(29) give
,
, (33)
and therefore,
. (34)
So we observe that even when the system is non-dissipative, half the initial gravitational potential energy will be stored in the spring while the other half is lost.
5. Conclusion
In this paper, we examined the dynamics of a classical system during its transition from a non-equilibrium state to a final equilibrium one. The position of the system at the end of the nth-half cycle was calculated. The even and odd half cycle was examined and our results for the final position are consistent with force balancing for each parity of n. The number of half cycles is determined by the masses of the connected blocks and the coefficient of kinetic friction. Furthermore, the total distance covered by the system was determined. The energy involved during the system’s transition was calculated for the two parity cases of n. Our results show that in the limit of vanishing coefficient of friction the energy stored in the spring is exactly half the initial gravitational potential energy and the other half is an energy loss. This is in complete analogy with the energy loss in the two-capacitor problem.
Conflicts of Interest
The author declares no conflicts of interest regarding the publication of this paper.