Single Carrier Frequency Domain Equalization with Space-Time Trellis Codes ()
1. Introduction
Wireless communication is constantly expanding in scope, complexity, and high demand of data usage thereby boosting its research profile. As demand rises, there is a prevailing need to address multipath fading and intersymbol interference (ISI) [1] . In mobile outdoors environment, where a characterizing-mark is the absence of the line-of-sight, multipath fading and ISI influence is unavoidable. To mitigate this effect, a multicarrier scheme―OFDM―has constantly been incorporated in mobile designs. OFDM performs Fast Fourier Transform (FFT) operation on transmitted and received signals over parallel subcarrier thereby reducing or eliminating interference [2] [3] . Although OFDM has proven limited success in combating ISI and multipath fading, it has inherent drawback because as the capacity of MIMO systems increases, other destructive effects affect the propagation channels and/or overall system performance [4] . Equalization techniques (time and frequency domain), as well as space-diversity techniques, are being applied to mitigate these effects [5] [6] [7] [8] . As such, research interest has increased, on how to improve performance in the mediums where slow and fast fading and ISI permeate, working on several combinatorial techniques to achieving improved effective throughput. In this study, space-time coding technique (STTC) was combined with SC-FDE using the rank-determinant criteria. SC-FDE has a similar performance as OFDM [9] [10] , however SC-FDE has a lower average peak-to-power ratio than OFDM, making its dynamic range of power amplification lesser than OFDM. The background information on STTC and SC-FDE was examined, as well as the effect on the overall performance when combining coding with equalization at the receiver.
2. Background Space-Time Codes Theory
Tarokh et al. [8] pioneered the concept of space-time coding. Data sequence is propagated in space over nt number of transmit antennas, and in time, over t symbol periods yielding (nt × t) codeword and coding rate that is a fraction of the number of sequence over the symbol period.
Performance Analysis of Space-Time Codes
The performance of any wireless communication system is a measure of the percentage number of bits in error. The performance index of space-time-code is determined by the BER performance: a measure of the distance attributes of the code [11] . The BER performance analysis of space-time code can be examined by considering the Pairwise Error Probability (PEP). Generally, in the design of space-time codes, quasi-static fading model of MIMO is usually adopted [12] .
Considering a space-time coding system with nt transmit antenna and nR receive antenna over spatially correlated Rayleigh fading channel. The received sequence is denoted by
(1)
where X, H, and N denote the transmitted signal, channel matrix, and additive white noise, respectively, and corresponding dimensions
where T is the symbol durations through nt transmit antennas,
, and
. Suppose the channel is known to the receiver, and a codeword
was transmitted and the receiver decides erroneously in favor of signal
, then a difference matrix can be obtained as [8] [13] :
(2)
In the Rayleigh fading channel, the Ricean factor equals to zero. Therefore, the average pairwise error probability (PEP, or simply
) between two arbitrary codewords C and E over independent and identically distributed Rayleigh fading channels is written as [7]
(3)
(4)
where
is the spatio-temporal correlation matrix;
is the rank of
;
is the effective signal-to-noise-ratio, SNR;
is intergrated over the maximum at
. Equation (4) is obtained from
the Gaussian Q-function.
Ensuring that the code is not rank-deficient, suppose the Rayleigh fading channel is stable per frame, Equation (4) can thus be reduced to [14]
(5)
when
.
and
are the receive and transmit correlation matrices, respectively. At high SNR, Equation (5) results in
(6)
In space-time coding, for slow fades, the rank-determinant criterion is usually used [9] [15] . So,
(7)
However, for high SNR using the rank-determinant criterion, Equation (7) leads to
(8)
where
is the
th power of
.
Maximization of the rank of the error matrix
gives the diversity gain.
Coding gain is obtained by maximizing the
quantity.
3. System Model of STTC and SC-FDE
Consider a single carrier block transmission after serial binary bits being mapped into parallel bits, and the cyclic prefix (CP) inserted into the blocks of bits, as shown in Figure 1. The prefixed data stream is grouped (L-blocked) into serial combination and sent through the channel. This explains the simplicity of the single-carrier block transmission at the transmit side [10] [16] . In combining with STTC, the output streams from the encoder are appended with the cyclic prefix, which must be longer than the channel delay spread. These N + L streams of data are sent through the wireless channel after parallel conversion.
Assuming s(t) was encoded into nt streams of data x(t) expressed as
(9)
and when appended with CP of length L becomes
(10)
At the receiver, the received signal is given by
(11)
where
is the number of receive antennas,
is the effective SNR additive white Gaussian noise at time t of antenna j;
is the transmitted signal from i number of transmit antenna;
is the complex channel coefficient. By considering the channel to be slowly fading, then Equation (11) can be written as
(12)
Figure 1. A single-carrier Space Time Trellis Code (STTC) model.
where
is a block-wise circulant square matrix of size T × T in the form:
(13)
Obtaining the singular value decomposition,
becomes
, where
is a diagonal matrix whose elements are obtained by a block-wise FFT of
,
is the Discrete Fourier Transform (DFT) matrix.
(14)
The eigenvectors of
are independent of channel matrices H(l) [7] ,
bears the full information of the channel which the FFT operation requires. Applying FFT operation on the received vector, we have
(15)
Performing equalization using the minimum mean square, which minimizes the mean square error between the estimated and received symbols, and assuming an MMSE equalizer coefficient, we write Equation (15) as
(16)
where
is the signal-to-noise ratio, W is the equalizer coefficient, and
, noise as a result of equalization. Performing inverse FFT on Equation (16) results
(17)
which is consistent with [17] .
4. Simulation Results
The Bit Error Rate (BER) evaluation of the combined model over spatially correlated Rayleigh fading channels was done. Table 1 shows the parameters used for simulation.
Table 1. Major simulation parameters.
It was observed from the results shown in Figure 2 that for the same conditions and low SNR; that is, SNR ≤ 15 dB, the BER performances of basic STTC and STTC-FDE using MMSE systems were virtually the same. However, BER performance improves marginally as the channel becomes noisy for STTC-FDE as compared to the basic STTC. This result demonstrates that although it is possible to achieve higher level of coding gain with trellis coding alone, but in wireless communication systems targeting at broadband and mobile transmissions commonly face the challenge of fading channels that are both time and frequency selective, the use of space-time coding with equalization in the frequency domain improves the performance of the systems.
Figure 3 shows the average pairwise error probability (PEP) of basic STTC and STTC-FDE using MMSE. Minimum PEP results in space-time code when the Euclidean distance is maximized. It was observed that at low SNR, the PEP was high in both systems. At high SNR (i.e. SNR ≥ 12 dB), the PEP was reduced for both STTC-MMSE. The diversity order played a key role in obtaining the PEP. It was observed that the plot of STTC-MMSE gradually slopes down from a low SNR to high SNR. For the STTC, PEP gap was maintained evenly. At BER = 10−4, the PEP obtained for STTC-MMSE had a gain of 6 dB compared to the STTC.
The operation of having to decode the transmitted symbol in the time domain could explain the gain. The probability that the decoder would select an erroneous signal was low due to the fact that equalization and the FFT/IFFT operations were carried out before the STTC decoding. More studies are continuing on large antenna configuration.
Figure 2. Average BER-SNR performance of STTC and STTC-MMSE.
Figure 3. Average PEP-SNR performance plot of STTC and STTC-MMSE.
5. Conclusion
This paper has examined the performance of wireless communication when space-time trellis code is combined with Equalization in single-carrier transmission. In combining the two techniques, it was observed that BER increases marginally for STTC-MMSE compared to the basic STTC. Pairwise Error Probability shows an improved performance of STTC-MMSE over the traditional STTC. The error analysis obtained shows the viability of implementing a combination of diversity with frequency equalization in wireless communication.