Studies on Photocatalytic Degradation of Acridine Orange and Chloroform Sensing Using As-Grown Antimony oxide Microstructures
Aslam Jamal, Mohammed M Rahman, M. Faisal, Sher Bahadar Khan
DOI: 10.4236/msa.2011.26093   PDF    HTML     6,852 Downloads   11,493 Views   Citations


Flower shaped antimony oxide (Sb2O3) microstructures were synthesized in a large quantity via simple solution method using aqueous mixtures of antimony chloride and hexamethylene diamine (HMDA). The morphological characterizations were done by field emission scanning electron microscopy (FESEM), which revealed that the synthesized products possess flower-shaped microstructures. The detailed structural characterizations performed by X-ray diffraction (XRD), Fourier transform infrared spectrophotometer (FT-IR) and Raman spectrophotometer confirmed that the synthesized microstructures are well-crystalline antimony oxide. The Energy dispersive spectroscopy (EDS) shows that the grown products are composed of Sb and O. Optical properties of the synthesized products were characterized by UV-Visible spectrophotometer which exhibits a well defined peak at ~ 291.0 nm. The photo-catalytic activity of the Sb2O3 microstructures was evaluated by degradation of acridine orange (AO), which mineralized almost 63.0% in 150 min. The chemical sensing properties of Sb2O3 microstructures was also studied by I-V technique using chloroform as a detecting solvent. The fabricated chloroform sensor demonstrates good sensitivity of 0.1154 µA cm–2 mM–1, lower-detection limit (~0.1 mM), large-linear dynamic range (LDR, 0.122 mM to 1.22 M) with linearity (R = 0.7898) in short response time (10.0 sec).

Share and Cite:

A. Jamal, M. Rahman, M. Faisal and S. Khan, "Studies on Photocatalytic Degradation of Acridine Orange and Chloroform Sensing Using As-Grown Antimony oxide Microstructures," Materials Sciences and Applications, Vol. 2 No. 6, 2011, pp. 676-683. doi: 10.4236/msa.2011.26093.

Conflicts of Interest

The authors declare no conflicts of interest.


[1] K. Ozawa, Y. Sakka and A. Amamo, “Preparation and electrical conductivity of three types of antimonic acid films” Journal of materials research, Vol. 13. No. 4, April 1998, pp. 830-833.
[2] K. S. Liu, J. Zhai, and L. Jiang, “Fabrication and characterization of superhydrophobic Sb2O3 films” Nanotechnology, Vol. 19 No. 16, December 2008, pp. 165604.
[3] Z.T. Deng, D. Chen, F.Q. Tang, X.W. Meng, J. Ren, and L. Zhang, “Orientated attachment assisted self-assembly of Sb2O3 nanorods and nanowires: End-to-end versus side-by-side” Journal of Physical Chemistry, Vol. 111, No.14, March 2007, pp. 5325-5330.
[4] Y.X. Zhang, G.H. Li and L.D. Zhang, “Growth of Sb2O3 Nanotubes via a Simple Surfactant-assisted Solvothermal Process ” Chemistry Letters, Vol. 33, No. 3, March 2004, pp. 334-335.
[5] S.B. Khan, M. Faisal, M.M. Rahman, A. Jamal, “Low-temperature Growth of ZnO Nanoparticles: Photocatalyst and Acetone Sensors” Talanta, March (2011) (doi:10.1016/j.talanta.2011.05.003).
[6] M. Faisal, S.B. Khan, M.M. Rahman, A. Jamal, A. Umar. “Ethanol chemi-sensor: Evaluation of structural, optical and sensing properties of CuO nanosheets” Mater. Lett. Vol. 65 February 2001, pp. 1400-1403.
[7] B.J. Li, Y.B. Zhao, X.M. Xu, C.L. Zhang, Z.S. Wu and Z.J. Zhang, “Fabrication of Hollow Sb2O3 Microspheres by PEG Coil Template” Chemistry Letters, Vol. 35, No. 9, September 2006, pp. 1026- 1026.
[8] C.Ye, G.Meng, L.Zhang,G.Wang and Y.Wang, “ A facile vapor-solid synthetic route to Sb2O3 fibrils and tubules” Chemical physics Letters, Vol.363, September 2002, pp. 34-38.
[9] A. Umar, M.M. Rahman, Y.B. Hahn. “MgO polyhedral nanocages and nanocrystals based glucose biosensor”. Electrochemistry Communications, Vol. 11, 2009, pp. 1353-1357.
[10] M.M. Rahman, A. Jamal, S.B. Khan, M. Faisal, “Characterization and applications of as grown β-Fe2O3 nanoparticles prepared by hydrothermal method” J. Nanopart. Res. (2011) (doi 10.1007/s11051-011-0301-7).
[11] R.W. Siegel, “Nanostructured materials –mind over matter-” Nanostructured Materials, Vol. 4, No.1, January – February 1994, pp. 121-138.
[12] A. Umar, M.M. Rahman, A. Al-Hajry, Y.B. Hahn. “Highly-sensitive cholesterol biosensor based on well-crystallized flower-shaped ZnO nanostructures”. Talanta, Vol. 78, July 2009, pp.284-289.
[13] P. Liu, Y.H. Zhang, M.W. Zhang, W.H. Zhang, Y.T. Qian, “Preparation of nanocrystalline antimony oxide powders by use of γ-ray radiation - oxidization route” Materials Science and Engineering B, Vol. 49, No. 1 , September 1997, pp. 42-45.
[14] C.G. Granqvist, R.A. Buhrmann, “Ultrafine Metal Particles”, Journal of applied Physics, Vol. 47, No. 5, May 1976, pp. 2200-2219.
[15] Z.L. Zhang, L. Guo, W.D. Wang, “Synthesis and Characterization of antimony oxide nanoparticles” Journal of materials Research, Vol. 16, No. 3, March 2001, pp. 803-805.
[16] M. Faisal, M. A. Tariq, M. Muneer, “Photocatalysed degradation of two selected dyes in UV-irradiated aqueous suspensions of Titania” Dyes Pigments, Vol. 72, No., January 2007, pp.233-239.
[17] S.B. Khan, M. Faisal, M.M. Rahman, A. Jamal, “Exploration of CeO2 nanoparticles as a chemi-sensor and photo-catalyst for environmental applications”. Sci. Tot. Environ. (2011) (doi:10.1016/j.scitotenv.2011.04.019).
[18] A. Umar, M.M. Rahman, A. Al-Hajry, Y.-B. Hahn. “Enzymatic glucose biosensor based on flower-shaped copper oxide nanostructures composed of thin nanosheets”. Electrochemistry Communications, Vol. 11, 2009, pp. 278- 281.
[19] M.M. Rahman, A. Umar, K. Sawada. “Development of amperometric glucose biosensor based on glucose oxidase co-immobilized with multi-walled carbon nanotubes at low potential”. Sensors and Actuators B: Chemical, Vol. 137, March 2009, pp. 327-333.
[20] I.O. Mazali, W.C. Las and M. Cilense, “Synthesis and Characterization of Antimony Tartrate for Ceramic Precursors” Journal of Materials Synthesis and Processing, Vol. 7, No. 6, November 1999, pp. 387-391.
[21] Z. Deng, D. Chen, F. Tang, J. Ren, and A.J. Muscat; “Synthesis and purple-blue emission of antimony trioxide single-crystalline nanobelts with elliptical cross section” Nano Research, Vol. 2, No., 2009, pp. 151-160.
[22] D. Wang, Y. Zhou, C. Song and M. Shao, “Phase and morphology controllable synthesis of Sb2O3 microcrystals” Journal of Crystal Growth, Vol. 311, No. 15, July 2009, pp.3948-3953.
[23] Y. Hu, H. Zhang and H. Yang “Direct synthesis of Sb2O3 nanoparticles via hydrolysis-precipitation method” Journal of Alloys and Compounds, Vol. 428, No. 1-2, 2007, pp. 327-331.
[24] B.S. Naidu, M. Pandey, V. Sudarsan, R.K. Vatsa and R. Tewari, “Photoluminescence and Raman spectroscopic investigations of morphology assisted effects in Sb2O3” Chemical Physics Letters, Vol. 474, No. 1-3, May 2009, pp. 180-184.
[25] M. A. Tariq, M. Faisal and M. Muneer, “Semiconductor-mediated photocatalysed degradation of two selected azo dye derivatives, amaranth and bismarck brown in aqueous suspension” Journal of Hazardous Materials, Vol. 127, No. 1-3, 2005, pp.172-179.
[26] M. Faisal, S.B. Khan, M.M. Rahman, A. Jamal, “Role of ZnO-CeO2 nanostructures as a photocatalyst and chemi-sensor”. J. Mat. Sci. & Tech. (2011) (In press).

Copyright © 2024 by authors and Scientific Research Publishing Inc.

Creative Commons License

This work and the related PDF file are licensed under a Creative Commons Attribution 4.0 International License.