Properties of Zinc Ferrite Nanoparticles Due to PVP Mediation and Annealing at 500°C ()
1. Introduction
The advancement of Nanoparticles (NP) in recent times has been superior, especially due to the enhancement of their properties in relation to their bulk materials [1] [2] . The Ferrite Magnetic nanoparticles (FMNP) are grouped as the spinel, the hexagonal and the garnet, respectively, based on their crystal structure. Their distinct special crystal structure and magnetic properties are applied in various biomedicine, industries and material science such as the encapsulation of drug for drug delivery to a targeted site to circumvent side effect problems [3] [4] , cancerous cell/tumor treatment via magnetic resonance imaging (MRI), information storage in modern technology [5] , and therapeutics via hyperthermia [2] [6] . This is achieved using various synthetic methods such as hydrothermal [2] [7] , sol-gel [8] , microemulsion [9] , thermal decomposition [10] [11] , and chemical co-precipitation [12] . Their adopted procedures in the synthesis methods have a significant influence on the morphology, size and the shape of the NP [13] . Co-precipitation method has been shown to be the most appropriate for biomedical application since it does not require any complex reactants or toxic materials and is often conducted under room temperature [14] .
However, the most commonly studied FMNP is the spinel ferrite (SF) nanocrystals. These are very important inorganic nanomaterials when compared to their bulk counterpart as well as their optical, electronic, electrical and magnetic properties, respectively [14] [15] [16] [17] . The cubic structured SFs belong to the class of oxides with exceptional magnetic properties that have no preferred directions of magnetization [18] [19] . They have the crystal structure of the natural spinel of AB2O4 in which A (Zn, Mn, Co, or Ni) and B (Fe) display tetrahedral and octahedral cation sites respectively, whereas, O indicates the oxygen anion site [3] [17] [20] . They occur as magnetic semiconductors capable of generating magnetic nanospheres as a result of their simplicity and are non-toxicity in preparation [21] . The Zinc ferrite nanoparticles (ZFNPs) are SF nanoparticle.
There are challenges in controlling the shapes and dispersibility of the ZFNPs due to their large surface to volume ratio, which induces the large surface energy that is thermodynamically unstable and then produces an aggregation [22] . The application of this NP is limited, sequel to the large size. However, it has been shown that to increase the saturation magnetization in the super-paramagnetic region of materials is a superior method to advance their improvement [23] . To enhance the optimal applications of the NPs, polymer encapsulation is needed to reduce the agglomeration effect [14] [24] . ZFNPs encapsulated with polymers enhanced their stability, biocompatibility, conjugating ability and as well reduce the agglomeration for various applications. The hydrophilicity, non-toxicity, dispersibility, and biocompatibility properties of Poly (Vinyl Pyrrolidone) (PVP) make it an excellent capping agent of ZFNPs [14] .
In one of such studies, [9] has shown that it is possible to prepare designed oxide nanoparticles using stable colloidal solution as an aqueous pseudophase. In their work, [25] showed in the nonstoichiometry of ZFNPS as a function of the particle size that, with a decrease in the particle size, the compositional range of the zinc-ferrite spinel broadened. Also, [26] in their study showed that in the absence of PVP, the ZFNPS exhibited a paramagnetic behavior, whereas in the presence of PVP, they have super-paramagnetic behavior. However, these ZFNPS has shown to have improved colloidal aqueous stability as well as adequate antibacterial activities [7] [27] .
In this work, we report on the surface effect of PVP mediated and the annealing on the structural and magnetic properties of ZFNPs using the co-precipitation method. The objectives include evaluating the effect of the PVP and the annealing on the particle size, determining the degree of crystallinity and the phase composition, and establishing the presence of the metal oxide bands. The results should present a superior material for the various applications.
2. Materials and Method
The analytical grade, without further purification, of iron (III) nitrate nonahydrates (Fe (NO3)3∙9H2O) 99%, zinc nitrate hexahydrate (Zn (NO3)2∙6H2O) 99%, poly (vinyl pyrrolidone) (C6H9NO)n 99.9% (MW = 29,000) were used as precursors in the experiment. These were purchased from Sigma Aldrich and used without further purification. Distilled water (DW) was used all through the synthesis procedures.
2.1. Preparation of Zinc Ferrite Nanoparticle-Mediated with PVP
An aqueous solution of 0.2 mm of iron nitrate in 100 ml of DW and 0.1 mm of Zinc nitrate in 50 ml of DW were prepared. The mixed reaction was obtained in the stoichiometric ratio (Fe:Zn = 2:1) and stirred with a magnetic stirrer for 2 hours to obtain a homogeneous solution. The obtained solution was added, in a dropwise, into a reaction container of 100 ml of DW at 90˚C of 0.1 g PVP. The mixture was poured into an evaporating dish and heat at 80˚C in an evaporating heater to evaporate the water and later transferred to the oven for 24 hrs to complete the drying. The dried orange colored solid ZFNPs, and the PVP mediated ZFNPs that remained, were pulverized to form a powder. The ZFNPs powder and the polymer mediated ZFNPs were washed several times and later annealed at 500˚C for 3 hrs to enhance the crystallinity of the nanocrystals and the decomposition of organic compounds in an air atmosphere.
(1)
2.2. Characterization
The PVP mediated ZFNPS samples were characterized by powder X-ray diffraction (XRD). The powder crystallite samples were used at room temperature, employing a Shimadzu diffractometer model XRD 6000 with the CuKα (0.154 nm) radiation source in a 2θ range of 10˚ - 80˚. The surface morphology and the elemental composition of the samples were determined by the Scanning Electron Microscope (SEM) obtained using JEOL_SEM1010 SEM instrument. The elemental compositions of the samples were obtained by the energy-dispersive X-ray spectroscopy (EDX) attached to SEM microscope. The Fourier Transform Infrared (FTIR) (PerkinElmer FT-IR spectra 1650, version 10.03.02) model spectrometer with 256 scans and 6 cm−1 resolution in the range of 4000 cm−1 to 500 cm−1 gave the functional groups. The magnetization via hysteresis loop at room temperature was conducted using a vibrating sample magnetometer (VSM) (lake shore 4700) with a magnetic field range from −5 KOe to +5 KOe. Noteworthy is that the microstructure and morphology of the nanoparticles is not within the scope of this study hence the samples were not exposed to the transmission electron miscroscopy.
3. Results and Discussions
3.1. SEM and EDX Analysis
The SEM images in Figures 1(a)-(d) shows the size distribution of the ZFNPs as-prepared, the PVP mediated samples and the annealed samples at 500˚C. The ZFNPs as-prepared is highly agglomerated with an average particle size of 52 nm, which decreases to 41 nm after the annealing. The effect of the PVP on the ZFNP is in reducing the agglomeration to an average particle size of 51 nm, whereas, after the annealing the particle reduces to 30 nm. It is obvious that the samples obtained at 500˚C were uniform in their morphology and decreased in particle size. The decrease in size is as a result of the melting of their surfaces, which were also observed in nickel ferrite and cobalt ferrite [6] . The EDX analysis shows strong signal in the iron and zinc region, which emphasized the presence of iron and zinc nanoparticles with optical absorption peak ≈ 6.4 keV and ≈ 1.0 keV, respectively, sequel to the Surface Plasmon Resonance (SPR). Along with iron and zinc in the EDX graph are oxygen and carbon, which might be caused by content present in the polymer. The percentage of the Fe and Zn content increases, respectively, after the annealing.
3.2. XRD Analysis
In the XRD result is shown the formation of cubic spinel structures without the noticeable traces of impurity phases for the PVP mediated samples coupled with annealing (Figure 2). The backgrounds of the un-annealed samples (Figure 2(a) and Figure 2(c)) are seen to be different. The index peaks at (220), (311), (400), (422), (511), (440) and (533), respectively, reveals the cubic spinel of Zinc ferrite without the impurity phase (JCPDS card no. 36-0398). Further analysis on the XRD outputs was carried out using the Scherer formula, given by the equation,
(2)
where D is the crystalline size (nm), λ is the X-ray wavelength (λ = 1.5406 Å), β is the full width at half maximum (FWHM) intensity measured in radians and θ is the Bragg diffraction angle [28] . The strain has been considered during the calculation of the crystallite size [29] . The analysis result confirms the average particle size of 1.3 nm to 15.2 nm and from 1.6 nm to 21.1 nm in the ZFNPs as-prepared to the annealed samples, as well as in the PVP mediated sample (Table 1).
Figure 1. The SEM micrograph (left panels) and the EDX analysis (right panels) of (a) ZFNPs as-prepared (un-annealed), (b) ZFNPs as-prepared (annealed), (c) ZFNPs PVP mediated (un-annealed), and (d) ZFNPs PVP mediated (annealed).
3.3. FTIR Analysis
The FTIR analysis results of the ZFNPs as-prepared, the PVP mediated samples and the annealed samples are presented in Figure 3. The peaks at 750 cm−1 and 704 cm−1 are due to the stretching vibration mode for Fe-O and Zn-O, respectively.
Figure 2. The XRD analysis of the (a) ZFNPs as-prepared (gray line), (b) ZFNPs as-prepared and annealed at 500˚C (red line), (c) PVP mediated ZFNPs (blue line), and (d) PVP mediated ZFNPs and annealed at 500˚C (green line).
Table 1. Crystalline sizes of the ZFNPs as-prepared, the PVP mediated and the calcined samples, respectively.
r* before annealing; r** after annealing.
The peaks at 1055 cm−1 in the ZFNPs as-prepared and 1066 cm−1 in the PVP mediated ZFNPs are attributed to the C-C stretching that changes to 1030 cm−1 after the annealing, respectively. The Carbonyl group (C=O) absorbs energy at 1634 cm−1 in the ZFNPs as-prepared and at 1622 cm−1 in the PVP mediated samples, which increased to 1634 cm−1 and 17131 cm−1 after the annealing. The peaks at 1429 cm−1 in the ZFNPs as-prepared and at 1330 cm−1 in the PVP mediated ZFNPs are attributed to CH2 bending, which increases to 1490 cm-1 and 1525 cm−1 after the annealing. The broadest peaks observed at 3204 cm−1 in the ZFNPs as-prepared and at 3216 cm−1 in the PVP mediated ZFNPs are due to an O-H group, which gives no peak for ZFNPs as-prepared and is 2975 cm−1 in the PVP mediated ZFNPs. The presence of the functional groups; C=O, C-N, C-C, C-H and O-H, confirms the presence of the PVP compound in ZFNPs.
3.4. VSM Analysis
Figure 4 shows the relationship between the magnetic field and the magnetization of the sample as-prepared, and at 500˚C. The result indicates that the samples
Figure 3. The FTIR analysis of the (a) ZFNPs as prepared (black line), (b) ZFNPs annealed at 500˚C (red line), (c) ZFNPs mediated with PVP (blue line), (d) ZFNPs mediated with PVP and annealed at 500˚C (green line).
Figure 4. The VSM analysis of the un-annealed and the annealed (a) ZFNPs as-prepared (left), and (b) PVP mediated ZFNPs (right).
showed zero coercivity and zero remanent magnetization (no hysteresis) at the 500˚C annealed temperature when compared with the un-annealed sample. This suggests that the superparamagnetic (SPM) behavior is in consonance with the state-of-the-art results of [30] . The hysteresis loop of the samples confirms that the magnetic behavior of the ZFNPs is highly influenced by the mediating PVP and the annealing, moving it from the ferromagnetic (un-annealed) to the SPM behavior (annealed).
4. Conclusion
The ZFNPs as-prepared, the PVP mediated and the annealed were synthesized via the co-precipitation method. The effects of the PVP and the annealing at 500˚C on the structural and magnetic properties, respectively, have been analyzed. The XRD analysis reveals the increase in the crystallite size after the PVP mediation and the annealing of the samples, respectively. The XRD analysis of the annealed samples indicates the intense and sharp peaks when compared to the un-annealed samples. The SEM images reveal increment in the particle size of the PVP mediated and the annealed samples, respectively. The EDX analysis has revealed the strong signals of the component elements in the samples. The FTIR analysis has confirmed the presence of the PVP on the surface of ZFNPs with a red shift of the annealed sample as a result of the cationic distribution on the lattice sites. The magnetic properties of the samples changed from a ferromagnetic to an SPM as an effect of the PVP mediated and the annealing. This SPM behavior of the ZFNPs as-prepared and the PVP mediated, respectively, has been achieved by annealing the samples at 500˚C for 3 hrs. The PVP mediated and annealing effects on the structural and magnetic properties of ZFNPs present a superior material for sundry applications. However, further studies on the morphology and the microstructure of ZFNPs are imperative in enhancing the applicability.