EPE> Vol.7 No.10, September 2015

Author(s)    Leave a comment

Wissam M. Alobaidi^1*, Entidhar A. Alkuam², Eric Sandgren¹, Hussain M. Al-Rizzo¹

¹Systems Engineering Department, Donaghey College of Engineering & Information Technology, University of Arkansas at Little Rock, Little Rock, Arkansas, USA.
²Department of Physics and Astronomy, College of Arts, Letters, and Sciences, University of Arkansas at Little Rock, Little Rock, Arkansas, USA.

The research reported in this paper aims at developing means of Non Destructive testing (NDT) to increase the line efficiency of pipe production in oil and natural gas pipe manufacturing plants using the Standard Allowed Minutes (SAM) method. Existing line production stations encounter difficulties in maintaining the recommended testing speed of smaller diameter pipe, due to limitations in the Visual Inspection (VI) station. We propose to implement one additional technique which will prevent the decline of line efficiency in a pipe production factory. The range of diameters identified as a problem in this research is from 254 mm to 762 mm. Microwave techniques are expected to improve the line efficiency by increasing the production of the plant. This happens as a consequence of maintaining the production rates of the identified pipe diameters, so that they equal the production output of the larger pipe diameters. We analyze the velocity traveled by the pipe through Radiographic Testing (RT) according to the VI output (production). The RT velocity is decreased for the diameters identified above, in order to maintain quality control and cover the shortcoming of the VI. The number of pipes produced is computed during shift hours of the factory and pipe lengths of the forming department are determined. We compare the output (production) of a series of NDT line stations with and without the microwave technique for the first of the three pipe cases considered in this study, classified as perfect pipe (PP), repair pipe (RP) and scrap pipe (SP). The velocity of RT stations analyzed in the paper ranges from 50 mm/s for larger diameter pipe, and decline to 16.667 mm/s for the identified diameters. The analytical calculations of line output (production) and line efficiency demonstrate the solution of this velocity problem after the microwave technique is introduced. It demonstrates that an economical and precise methodology to extend the production capability of the pipe plant has been determined.

Microwave Technology, Non Destructive Testing (NDT), Spiral Pipe Process (SPP), Pipe Inspection, Standard Allowed Minutes (SAM)

Alobaidi, W. , Alkuam, E. , Sandgren, E. and Al-Rizzo, H. (2015) Enhancing Production Efficiency of Oil and Natural Gas Pipes Using Microwave Technology. Energy and Power Engineering, 7, 440-450. doi: 10.4236/epe.2015.710043.