In Deep UV Quantitative Analysis of Multi-Element Low Alloy Steel by Laser-Induced Breakdown Spectroscopy


The multi-element components of low alloy steel were quantified by using laser-induced breakdown spectroscopy (LIBS) in deep UV. The Nd:YAG pulsed laser was used to produce plasma. The spectrum was simultaneously obtained by deep UV spectrometer. This paper studied the influence of experiment parameters on LIBS spectral intensity, such as delay, energy of laser, and the distance between the focusing lens and the surface of the sample. With the optimal expe- riment parameters, the characteristic lines of C, Ni, Si, Cr and Cu contained in low alloy steel were selected for quantit- ative analysis and the calibration curves of these elements were obtained. The linear correlation coefficient was good. Using the calibration curves to quantitative analysis for the sample 05-d, and the relative error of analytical results is less than 10% for most elements.

Share and Cite:

Xin, Y. , Sun, L. , Cong, Z. , Qi, L. , Li, Y. and Yang, Z. (2013) In Deep UV Quantitative Analysis of Multi-Element Low Alloy Steel by Laser-Induced Breakdown Spectroscopy. Journal of Computer and Communications, 1, 19-22. doi: 10.4236/jcc.2013.17005.

Conflicts of Interest

The authors declare no conflicts of interest.


[1] D. A. Cremers and L. J. Radziemski, “Handbook of Laser-Induced Breakdown Spectroscopy: Methods and Applications,” Wiley Press, 2006.
[2] A. W. Miziolek, V. Palleschi, I. Schechter, et al., “Lase-Induced Breakdown Spectroscopy Fundamentals and Applications,” Cambridge University Press, 2006.
[3] J. Vrenegor, R. Noll and V. Sturm,“Investigation of Matrix Effects in Laser-Induced Breakdown Spectroscopy Plasmas of High-Alloy Steel for Matrix and Minor Elements,”Spectrochim Acta B, Vol. 60, No. 7-8, 2005, pp. 1083-1091.
[4] F. Capitelli, F. Colao, M. R. Provenzano, et al.,“Determination of Heavy Metals in Soils by Laser Induced Breakdown Spectroscopy,”Geoderma, Vol. 106, No. 1, 2002, pp. 45-62.
[5] G. Wu, J. D. Lu and L. Y. Yu, “The Determination of Carbon Content in Ashes by Laser-Induced Breakdown Spectroscopy,” Journal of Engineering for Thermal Energy and Power, Vol. 20, No. 4, 2005, pp. 365-368.
[6] L. M. Cabalin and J. J. Laserna, “Experimental Determination of Laser Induced Breakdown Thresholds of Metals under Nanosecond Q-Switched Laser Operation,” Spectrochim Acta B, Vol. 53, No. 5, 1998, pp. 723-730.
[7] L. X. Sun and H. B. Yu, “Simultaneous Quantitative Analysis of Multielement in Al Alloy Samples by Laser-Induced Breakdown Spectroscopy,” Spectroscopy and Spectral Analysis, Vol. 29, No. 12, 2009, pp. 3375-3378.
[8] L. X. Sun, H. B. Yu and Y. Xin, “On-Line Monitoring of Molten Steel Compositions by Laser-Induced Breakdown Spectroscopy,” Chinese Journal of Lasers, Vol. 38, No. 9, 2011, Article ID: 091500.

Copyright © 2021 by authors and Scientific Research Publishing Inc.

Creative Commons License

This work and the related PDF file are licensed under a Creative Commons Attribution 4.0 International License.