Rib and Groove Type Wind Guide Plate Analysis for Wind Power System ()
Abstract
This research is the analysis of rib and groove type wind guide plate for wind generation power system. This device generates electricity by the air flow producing by the high-speed vehicles driving on the road. It can produce electricity as long as there are car passing on the high way. The effect is much more efficient in heavy traffic with high speed. If we can set up a large number of this system along the highway, it can provide the lighting in the highway at night but also sell the extra electricity to the power companies with low cost, high performances and improvement of environmental benefits.
Share and Cite:
C. Ming, "Rib and Groove Type Wind Guide Plate Analysis for Wind Power System,"
Smart Grid and Renewable Energy, Vol. 3 No. 4, 2012, pp. 334-337. doi:
10.4236/sgre.2012.34044.
Conflicts of Interest
The authors declare no conflicts of interest.
References
|
[1]
|
S. Arya, “Introduction to Micrometeorology,” Academic Press, New York, 1988, p. 303.
|
|
[2]
|
P. Koch, H. Wernli and H. C. Davies, “An Event-Based Jet-Stream Climatology and Typology,” International Journal of Climatology, Vol. 26, No. 3, 2006, pp. 283-301. doi:10.1002/joc.1255
|
|
[3]
|
I. Argatov, P. Rautakorpi and R. Silvennoinen, “Estimation of the Mechanical Energy Output of the Kite Wind Generator,” Renewable Energy, Vol. 34, 2009, pp. 1525-1532. doi:10.1016/j.renene.2008.11.001
|
|
[4]
|
R. Y. Redlinger, P. D. Andersen and P. E. Morthorst, “Wind Energy in the 21st Century,” Palgrave Publishers Ltd., New York, 2002.
|