Author(s)

S. Jawahar¹, P. Ramamoorthy²

¹HOD/Electrical, VSVN Polytechnic College, Virudhunagar, India.
²ECE, Adhitya Institute of Technology, Coimbatore, India.

The various configurations of multilevel inverter involve the use of more numbers of switching devices, energy storage devices and/or unidirectional devices. Each switching unit necessitates the add-on driver circuit for proper functionality. Cascaded H-Bridge Multilevel Inverter requires overlapped switching pulses for the switching devices in positive and negative arms of the bridge which may lead to short circuit during the device failure. This work addresses the problems in different configurations of multilevel inverter by using reduced number of switching and energy storage devices and driver circuits. In the present approach Single Switch is used for each stair case positive output and single H-Bridge for phase reversal. Driver circuits are reduced by using the property of body diode of the MOSFET. Switching pulses are generated by Arduino Development Board. The circuit is simulated using Matlab. More so, through experimental means, it is physically tested and results are analyzed for the 5-step inverter and thereby simulation is fully validated. Consequently, cycloconverter operation of the circuit is simulated using Matlab. Moreover, half bridge configuration of the multilevel inverter is also analyzed for high frequency induction heating applications.

H-Bridge Multilevel Inverter, Single Switch Multilevel Inverter, Body Diode, Switching Angle, THD, Cycloconverter, Half Bridge Multilevel Inverter

Jawahar, S. and Ramamoorthy, P. (2016) Minimization of Switching Devices and Driver Circuits in Multilevel Inverter. Circuits and Systems, 7, 3371-3383. doi: 10.4236/cs.2016.710287.