Author(s)

Tri Karian^1,2, Hideki Shimada¹, Takashi Sasaoka¹, Sugeng Wahyudi¹, Deyu Qian¹, Budi Sulistianto²

¹Department of Earth Resources Engineering, Kyushu University, Fukuoka, Japan.
²Department of Mining Engineering, Institut Teknologi Bandung, Bandung, Indonesia.

Maintaining stability as well as optimizing recovery of crown pillar, a pillar separating surface area with the uppermost stope in overhand cut and fill underground mining method, is important. Failures in stope may lead to crown pillar failures and cause surface subsidence. Increasing crown pillar thickness will increase crown pillar stability yet reduce mining recovery because part of crown pillar is formed by ore body. Preventing stope failure is the key to maintain stability and optimize recovery of crown pillar. Therefore, it is important to study countermeasure method for stope failure especially in crown pillar area. An attempt has been made to investigate the effectiveness of various countermeasures for stope failure in crown pillar area by means of parametric study. The result shows active type support system is effective for supporting stope in high vertical stress condition while the passive one needs to be installed if the stope is opened in high horizontal stress condition. In general, more supporting capacity from both type support systems is needed if the stope is opened in more severe geological condition. Another countermeasures, sill pillar and surface pile, are introduced for stope instability in crown pillar and non-crown pillar area. Sill pillar is an abandoned slice of unstable stope based on stability analysis. Sill pillar is very effective to stabilize stope both in crown pillar and non-crown pillar area, especially for stope in high horizontal stress condition. Sill pillar application in model with stress ratio 2 can optimize 20 meter thickness of crown pillar into 5 meter. Another proposed countermeasure is surface pile. Surface pile can be installed from the surface to improve stability of crown pillar and stope. The most effective use of surface pile is found in simulation of model with stress ratio 0.75 where surface pile can optimize 15 meter thickness of crown pillar into 5 meter.

Crown Pillar, Stope Stability, Active and Passive Type Support System, Sill Pillar, Surface Pile

Karian, T. , Shimada, H. , Sasaoka, T. , Wahyudi, S. , Qian, D. and Sulistianto, B. (2016) Countermeasure Method for Stope Instability in Crown Pillar Area of Cut and Fill Underground Mine. International Journal of Geosciences, 7, 280-300. doi: 10.4236/ijg.2016.73022.