Author(s)

Jwo Ming Jou

Department of Mechanical Engineering, Cheng Shiu University, Taipei city.

In this paper, we want to make a new type linear piezoelectric motor by mode shape coating or effective electrode surface coating. The mode shape is derived from the mechanical boundary conditions of the linear piezoelectric motor. We only have access to the first three modes of formas, the effective electrode surface coating basis, as well as with the linear piezoelectric motor of normal shape do comparison. Next, we will inspect their gain or axial velocity through theoretical analysis, simulation and experiment. According to the results of the theoretical analysis, we have found that the gain or axial velocity of the linear piezoelectric motors of mode shape is much larger than the linear piezoelectric motors of normal shape. However, according to the results of simulation and experiments, we have found that the gain or axial velocity of the linear piezoelectric motors of mode shape is much greater than the linear piezoelectric motors of normal shape, which is about 1.2 to 1.4 times. The linear piezoelectric motor of mode shape 3 has the fastest axial velocity, which is about -48 mm/s and 48 mm/s under conditions of 180 V_p-p driving voltage, 21.2 kHz driving frequency (the third vibration modal), 25 gw loading and the position of loading or mass at x = 5 mm & 45 mm respectively. And its axial velocity is about 1.4 times the linear piezoelectric motor of normal shape under the same conditions. Overall, the mode shape coating helps to enhance the gain or axial velocity of the linear piezoelectric motor.

Linear Piezoelectric Motor (LPM), Mode Shape (MS), Normal Shape (NS), Gain, Axial Velocity

Jou, J. (2015) A Study on the Linear Piezoelectric Motor of Mode Shape. Open Journal of Acoustics, 5, 153-171. doi: 10.4236/oja.2015.54013.