Effective Beneficiation of Low Grade Iron Ore Through Jigging Operation

B. Das, S. Prakash, S.K. Das, P.S.R. Reddy

Scientist, Institute of Minerals and Materials Technology (Council of Scientific and Industrial Research) Bhubaneswar-751013, Orissa, INDIA.

DOI: 10.4236/jmmce.2008.71002                

Abstract

The effectiveness of jigging operation for the beneficiation of low-grade iron ore deposits of Orissa, India has been investigated. Iron ore sample obtained from Barbil region of Orissa containing very high amount of silica and alumina was crushed using the laboratory jaw crusher and roll crusher to prepare different particle sizes. The sink and float tests were carried out to evaluate the possible response of the sample by gravity concentration technique. The samples were subjected to jigging in a laboratory Denver mineral jig and Harz jig. The operating variables used to determine the effectiveness of jigging include, particle size, velocity of water and amplitude. Recovery of iron values and the separation efficiency were assessed by determining mineralogy and the percentages of Fe in the jig concentrate and tailings by wet chemical and X-ray floroscence (XRF) techniques. Optimum iron ore recovery of 78.6% was achieved with 63.7% Fe in concentrate when the jig was operated at medium stroke, with an average water velocity and at a particle size of below 5 mm. The results are very close to theoretical results obtained by sink and float studies.

Keywords

Low grade iron ore, mineralogy, jigging, particle size, water rate, separation efficiency.

Conflicts of Interest

The authors declare no conflicts of interest.

References

[1]	Rong, X Rui and Lyman, Geoffrey J., 1992, Fuel, vol. 71, 1, pp. 115.
[2]	Xia, Y.K. and Peng, F.F., 2007, Mineral Engineering, vol 20,2, pp.113.
[3]	Tsunekawa, M., Naoi, B., Takubo, T., Hirajima, T., Hiroyoshi, N., Otani, M., Miyamoto, M., and Ito, M., 2001,Jig separation of plastic waste used in copy machines, Proceeding 7th International Symposium on East Asian Resources Recycling Technology, The Korean Institute of Resources Recycling, pp592.
[4]	Tsunekawa, Masami., Naoi, Banryu., Ogawa, Shingo., Hori, Kunihiro., Hiroyoshi, Naoki., Ito, Masazumi and Hirajim, Tsuyoshi, 2005, Int. Journal of Mineral Processing vol, 76, 1-2, 4, pp67-74.
[5]	Olubambi, P.A. and Potgietez, J.H. 2005, Journal of Mineral and Material characterization and Engineering, vol.4, No.1, pp21.
[6]	Sripriya, R. and. Murty, Ch. V.G.K., 2005, Int. Journal of Mineral Processing, vol. 75, 1- 2, pp123.
[7]	Yang, David C., Reenan, Ricus van. and Bhimsan, Vima, 2003, Journal of Minerals and Material Characterization & Engineering. vol. 2, No.2, pp137.
[8]	Mukherjee, A.K. and Mishra, B.K., 2006, Mineral Engineering, vol 19, 9, pp.952.
[9]	Mukherjee, A.K. and Mishra, B.K. 2006, Int. Journal of Mineral Processing vol.81, 3, pp.187.
[10]	Mishra, B.K. and Adhikari, B. 1999, Mineral Engineering. vol. 12, 12, pp.1469.