Torque Free AxiSymmetric Gyros with Changing Moments of Inertia

The properties and characteristics of torque free gyros with rotational symmetry and changing moments of inertia are the subject of the subsequent discussion. It shall be understood that the symmetry can be expressed by the notation ( ) A B = which does not presuppose geometric symmetry, where A and B are the principle moments of inertia about x and y axes respectively. We study the case of a torque free gyro upon which no external torque is acting. The equations of motion are derived when the origin of the xyz-coordinate system coincides with the gyro’s mass center c. This study is useful for the satellites, which have rotational symmetry and changed inertia moments, the antennas and the solar power collector systems.


Introduction
A gyro is a body of rotation which is set spinning at a large angular velocity around its axis of symmetry.The most important practical applications of gyros are met in devices for measuring the orientation or maintaining the stability of airplanes, spacecrafts and submarine vehicles in general.Various gyros are used as sensors in inertial guidance systems.Most textbooks in introductory mechanics explain the mysterious behavior of a spinning gyro by using Lagrange equations and severe mathematics [1] [2].Other textbooks [3] [4] treat the problem of torque-induced precession of a top based on Euler equations, which are referred to the non-inertial reference frame rotating together with the body.The problem of the torque free inertial rotation of a symmetrical top is discussed, in particular, in [5] and illustrated by a simulation computer program (free rotation of an axially symmetrical body) [6].For our problem, we consider a gyro body with xyz-coordinate system fixed of it, such that the z-axis of the body is the axis of symmetry and the inertia tensor is assumed to take the form Here A and C are the principal moments of inertia in the x and z directions.
The rate of change of the inertia tensor with respect to time takes the form We note that the inertia products remain zeros.
Assume that the angular velocity of the satellite or the gyros is and the angular momentum is where ˆ, i j and k are the unit vectors in the , x y and z directions.
Thus the gyro's kinetic energy of rotation becomes

Equations of Motion
Applying Euler's equations of motion and putting the applied torque equal zero, we get ( ) For the considered problem (mentioned above) we apply the angular momentum principle to get ( ) ( ) (2.4c)

Components of Angular Momentum
The Equation (2.4c) can be integrated to give .

Cr Const =
We can conclude that the z-component of the angular moment is constant, that is The angular velocity is obtained by multiplying the Equations (2.4a) by Ap and (2.4b) by Aq and adding the resulted equations, we get ( ) ( ) where Thus the ν -component of angular momentum is constant The v ω and V h can be shown, see Figure 1.
For torque free axi-symmetric gyro, angular velocity ω , angular momentum h , Figure 1.The angular momentum components.
and the gyro's symmetry axis lie in one plane [7].
Since the Equations (3.1) and (3.5) represent the angular momentum components, it can be deduced that the nutation angle remains constant when the inertia moments change as it when the inertia moments does not change.
For the components of angular velocity (3.4), we introduce the auxiliary frequency α defined by then The two Equations (2.4a) and (2.4b) can be combined to yield The solution of this differential equation can be obtained as ( ) where the subscript (0) refers to values of time ( ) The components of angular velocity can be shown, see Figure 2.
The angular velocity component V ω has a relative angular velocity α in the xy- plane.
Introducing a floating v cu z coordinate system, we can express the angular velocity ( ω ) by using the cxyz or the  We can find that, for a flattened gyro ( ) , the v-axis rotates faster than the x-axis, and for elongated gyro ( ) A C > the v-axis rotates more slowly than the x-axis.
Thus, the v cu z coordinate system moves with an angular velocity The angular velocity ω of the gyro body and the angular velocity Ω of the float- ing v cu z coordinate system are related by where σ is the spin of the gyro.

Euler Frequencies
The frequency of the angular momentum remains constant since there is no external torque applied to the gyro [8], the direction of the angular momentum vector may be used to define as space-fixed coordinate axis L which assigned to Z-axis and is called the precession axis [9].
If the z-axis of the rotating v cu z coordinate system is the symmetry axis of the gyro, the v-axis lies in a plane formed by the Zand zaxes, and we write The nutation angle ν is the angle between the z-axis and Z-axis where Z-axis and L are coincide, see Figure 3.
The components of ω for elongated axis symmetric gyro are obtained from the shape, so sin , cos , sin , 3) The nutation angle remains a constant and the gyro is carry out a steady precession about the angular momentum vector, since  Also for the angle γ between the z-axis and the angular velocity ω axis, we have The motion of a torque free gyro with rotational symmetry and changing moment of inertia can be visualized by imaging a space cone and body cone as shown see Figure 4 and Figure 5.
We can obtain the relation between the precession and the spin as follows For the elongated gyro ( ) A C > we find that γ ν < and σ and ψ have the same sign then the precession is direct.
For the flattened gyro ( ) A C < we find that σ and ψ have the opposite signs, then the precession is retrograde.

Conclusions
The system (2.4) is integrated to obtain the angular velocities and the angular momentum,  1) the elongated gyro ( ) 2) the flattened gyro ( ) For each case, we investigate the equations of motions, the precession, the nutation and the spin for these motions in detailed by using the analytical techniques and the illustrated shapes.The obtained results can be applied on the satellites [10] with rotational symmetry and changed inertia moments, the antennas [11] [12] and the solar power collector systems [13].

. 9 )
If the constant 2 0 C = , and in order to find the value of constant 1 C we employ the Equation (3.5) to get 1 the ν -component of the angular velocity at any instant by using

v
cu z coordinate system.The Equations (3.11) and (3.12) show that the component V ω and consequently v-axis and u-axis are perpendicular, such that u-axis rotates with a relative angular velocity α where .C A r A α − = In the xy-plane, the z-component of the absolute angular velocity of v-axis is

Figure 2 .
Figure 2. The components of angular velocity.

Figure 4 .
Figure 4. Space cone and body cone for an elongated gyro.

Figure 5 .
Figure 5. Space cone and body cone for a flattened gyro.