Received 12 September 2015; accepted 25 October 2015; published 28 October 2015

ABSTRACT

In this paper, a new two-step Newton-type method with third-order convergence for solving systems of nonlinear equations is proposed. We construct the new method based on the integral interpolation of Newton’s method. Its cubic convergence and error equation are proved theoretically, and demonstrated numerically. Its application to systems of nonlinear equations and boundary-value problems of nonlinear ODEs are shown as well in the numerical examples.

Keywords:

Newton-Type Method, Systems of Nonlinear Equations, Third-Order Convergence, Integral Interpolation

1. Introduction

We consider a system of nonlinear equations as follows:

(1)

where, is a given nonlinear function with the following properties:

1) There exists an such that;

2) is continuously differentiable in a neighborhood of;

3) is a nonsingular matrix.

How to efficiently solve the system of nonlinear Equation (1) is a typical issue in scientific computation and engineering field. The most famous method is probably Newton’s method as follows (see [1] [2] ):

(2)

where x₀ is an initial guess of the root. This is one-step method, and it uses two evaluations of the function and derivative to achieve second-order convergence by iteration.

Besides, third-order iterative equations, such as the Halley iterative method and Chebyshev iterative method, are often used. In recent years, a few similar methods [3] -[9] with high-order have emerged for solving systems of nonlinear equations.

Especially, M. T. Darvish & A. Barati [3] used Adomian decomposition method to construct a third-order Newton-type scheme:

(3)

Frontini & Sormani [4] presented a third-order method in using numerical quadrature formulae to solve systems of nonlinear equations as follows:

(4)

These are classic two-step Newton-type methods to achieve cubic convergence to approximate the root of a system of nonlinear equations.

In this paper, we propose a new variant of two-step Newton’s method with the third-order convergence by quadrature formulae in Section 2, some numerical examples using this new method for solving systems of nonlinear equations and boundary-value problems of nonlinear ODEs in Section 3, and finally make conclusions in Section 4.

2. The New Method and Its Third-Order Convergence

Based on the multivariable mean-value theorem

(5)

we use the left rectangular integral rule

and use to get Newton Method (1). By using the trapezoidal integral rule

substituting with, and using, Weerakoon and Fernando [5] also derived a variant of Newton’s method with cubic convergence (3) for a nonlinear equation.

Now, we applied the quadrature formula

to construct the following new scheme:

(6)

We state and prove the convergence theorem as follows:

Theorem Let be k-time Fréchet differentiable function in a convex set D with a root and x₀ be close to, then the new of Newton-type method (6) is cubically convergent, and its error equation is

.

Proof. As, and note,.

By Taylor’s expansion, we have

(7)

, (8)

From

(9)

where is sufficiently small.

We have

By (6), therefore

.

And

where.

By Toylor’s expansion

(10)

Furthermore, by (8) and (10), we have

(11)

Finally, using (7), (11) and (6), we obtain the error equation as

That is

.

Using (9), so,

. (12)

This shows that the method is the third-order convergence.

The new scheme of two-step Newton-type method (6) uses three evaluations of the function and derivative per iteration to achieve third-order convergence for solving a simple root of systems of nonlinear equations. As the efficiency index is, the efficiency index of the Newton-type method is, whereas Newton’s method is.

3. Numerical Examples

The iterative method (6) is demonstrated by solving some systems of nonlinear equations and boundary-value problems of nonlinear ODE.

Example 1. Consider the system of nonlinear equation:

(13)

where,. We have numerical results in Table 1.

According to results of the numerical experiments, the new iterative method (6) can achieve super third-order convergence for some systems of nonlinear equations.

Example 2. We have numerical results in Table 2 for the following a system of nonlinear equations:

^*Corresponding author.

where,.

The above numerical results agree with the theoretical analysis on the convergence, and the iterative efficiency is comparative high.

Example 3. Consider solving the following boundary-value problem of nonlinear ODE:

(15)

Discretize the nonlinear ODE (15) with the finite difference method. Taking nodes, where and, we have a system of nine-dimensional nonlinear equations:

(16)

where, using the Newton-type method (6), we get the solutions of Equations (16), that is

The results for the system of nonlinear equations of ODE (15) are shown in Table 3.

4. Conclusion

In this paper, we presented a new two-step iterative method of cubic convergence to solve systems of nonlinear equations. Through theoretical analysis and numerical experiments, we believe that the new variant of Newton- type method is so efficient and fast convergent as to be able to find solutions with required accuracy. To sum up, this method is suitable for solving systems of nonlinear equations, and can be used to resolve boundary-value problems of nonlinear ordinary differential equations as well.

Acknowledgements

The work is funded by the Science & Technology Program of Beijing Municipal Commission of Education (No. KM201511417012).

Cite this paper

ZhongliLiu,QuanyouFang, (2015) A New Newton-Type Method with Third-Order for Solving Systems of Nonlinear Equations. Journal of Applied Mathematics and Physics,03,1256-1261. doi: 10.4236/jamp.2015.310154

References

NOTES

^*Corresponding author.