Tosi, L., Sridhara, V., Yang, Y., Guan, D., Shpilker, P., Segata, N., Larman, H.B. and Parekkadan, B. (2017) Long-Adapter Single-Strand Oligonucleotide Probes for the Massively Multiplexed Cloning of Kilobase Genome Regions. Nature Biomedical Engineering, 1, Article No. 0092.
https://doi.org/10.1038/s41551-017-0092

has been cited by the following article:

• TITLE: Optimization of High-Performance Liquid Chromatography Parameters for Purification of Oligonucleotide-A

  AUTHORS: Christina Perez, Mubeen Rani, Tuan Phan

  KEYWORDS: Purification, High-Performance Liquid Chromatography, Oligonucleotide-A, Dipotassium Phosphate, Triethylammonium Acetate, Triethylammonium Bicarbonate, Ammonium Acetate

  JOURNAL NAME: American Journal of Analytical Chemistry, Vol.13 No.2, February 28, 2022

  ABSTRACT: The modification of high-performance liquid chromatography parameters leads to a more effective oligonucleotide-A purification process. Using various experimental parameters such as buffer, concentration, and pH, a method for optimizing the purification of an oligonucleotide-A on a reverse-phase C18 column was created. To purify oligonucleotide-A, High-Performance Liquid Chromatography (HPLC), Ultraviolet-Visible Spectrophotometry (UV-Vis), Liquid Chromatography-Mass Spectrometry (LC-MS), and lyophilization were used. Chromatographic data were collected with a semi-prep HPLC system, quantified with the UV-Vis technique, and validated with the LC-MS method. The most optimized parameters found to obtain the purity of 93.0% are 40 mM triethylammonium bicarbonate (TEAB) buffer with pH 7, which is approximately 6.0% higher than the reported method of which the purity is 87.0%. However, the yield under these conditions was reduced by about 5%. The worst possible optimized settings that resulted in the lowest purity (84.0%) and yield (69.0%) are 10 mM ammonium acetate (NH4CH3CO2) with pH 7.