Lu, X. and Wei, J.-J. (2014) Experimental Study on a Novel Loop Heat Pipe with Both Flat Evaporator and Boiling Pool. International Journal of Heat and Mass Transfer, 79, 54-63.
http://dx.doi.org/10.1016/j.ijheatmasstransfer.2014.07.089

has been cited by the following article:

• TITLE: Development and Investigation of a Miniature Copper-Acetone Loop Heat Pipe with a Flat Evaporator

  AUTHORS: Yury F. Maydanik, Vladimir G. Pastukhov, Mariya A. Chernysheva

  KEYWORDS: Loop Heat Pipe, Flat Evaporator, Copper-Acetone, Different Orientation

  JOURNAL NAME: Journal of Electronics Cooling and Thermal Control, Vol.5 No.4, December 7, 2015

  ABSTRACT: The paper presents the results of development and investigation of a copper miniature loop heat pipe (LHP) with acetone as a working fluid. The device was equipped with a flat evaporator measuring 80 × 42 × 7 mm and vapor and liquid lines with an outside diameter of 3 mm, whose lengths were 145 mm and 175 mm, respectively. The LHP was tested at heat loads from 5 W to 60 W, different orientations in the gravity field and heat-sink temperatures from -40°C to +50°C. It is shown that the LHP retains its efficiency at all testing conditions. It is also mentioned that at a heat-sink temperature of +50°C the device operates in the mode of constant conductivity in the whole range of heat loads, and in this case a minimum thermal resistance of the “heat source-heat sink” system equal to 0.16°C/W is achieved, which is independent of the LHP orientation in the gravity field.