Rodrigues, C.C. (1993) Analysis of Drying of Suspensions in Spouted Bed with Inert Particles. MSC Dissertation, Federal University of São Carlos, São Carlos. (In Portuguese)

has been cited by the following article:

• TITLE: Influence of Bed Geometry on the Drying of Skimmed Milk in a Spouted Bed

  AUTHORS: Maisa Tonon Bitti Perazzini, Fábio Bentes Freire, José Teixeira Freire

  KEYWORDS: Cone Angle, Bed Geometry, Bed Configuration, Inert Particles, Neural Network

  JOURNAL NAME: Advances in Chemical Engineering and Science, Vol.5 No.4, October 12, 2015

  ABSTRACT: In this present work, the fluidynamic and drying process of skimmed milk in conical and conical-cylindrical spouted bed was analyzed as a function of different bed geometry and operating conditions. It used three internal cone angles (45°, 60° and 75°), different loads of inert particles (1.50, 3.00 and 4.50 kg) and a fixed static bed height (20.50 cm). Polyethylene particles of 4.38 mm of diameter and 930.50 ± 0.3 kg/m3 of specific mass were used as inert particles. An artificial neural network model was trained to predict the peak pressure drop and the minimum spout velocity from an experimental data bank. The experimental results showed a significant effect of geometric characteristics of the bed on fluidynamics parameters. It was also observed for the operating conditions that conical spouted bed and cone angle of 45° were more suitable for drying skimmed milk. The neural network provided predictions in good agreement with experimental data.