Horibe, A., Yu, J., Haruki, N. and Kamei, T. (2010) Fundamental Study on the Melting and Solidification Characteristic of Two Latent Heat Storage Materials and Their Compounds. 9th Asian Thermo-physical Properties Conference ATPC, Beijing, 19-22 October 2010, ATPC109071.

has been cited by the following article:

• TITLE: Melting and Solidification Heat Transfer Characteristics of a Phase-Change Material in a Latent Heat Storage Vessel: Effects of a Perforated Partition Plate and Metal Fiber

  AUTHORS: Than Tun Naing, Akihiko Horibe, Naoto Haruki, Yutaka Yamada

  KEYWORDS: Heat Storage Vessel, Solidified Height, Phase-Change Material (PCM), Mixture, Perforated Partition Plate, Metal Fiber

  JOURNAL NAME: Journal of Power and Energy Engineering, Vol.5 No.8, August 10, 2017

  ABSTRACT: Today, latent heat storage technology has advanced to allow reuse of waste heat in the middle-temperature range. This paper describes an approach to develop a latent heat storage system using middle-temperature waste heat (~100oC - 200oC) from factories. Direct contact melting and solidification behavior between a heat-transfer fluid (oil) and a latent heat storage material mixture were observed. The mixture consisted of mannitol and erythritol (Cm = 70 mass %, Ce = 30 mass %) as a phase-change material (PCM). The weight of the PCM was 3.0 kg and the flow rate of the oil, foil, was 1.0, 1.5, or 2.0 kg/min. To decrease the solidified height of the PCM mixture during the solidification process, a perforated partition plate was installed in the PCM region in the heat storage vessel. PCM coated oil droplets were broken by the perforated partition plate, preventing the solidified height of the PCM from increasing. The solidification and melting processes were repeated using metal fiber. It was found that installing the metal fiber was more effective than installing the perforated partition plate to prevent the flow out problem of the PCM.