Evaluation of the Equality of Non-Polar Capillary Columns in GC/MS Analysis of Food Contact Plastics

Motoh Mutsuga, Miku Yamaguchi, Yutaka Abe, Hiroshi Akiyama

Division of Food Additives, National Institute of Health Sciences, Tokyo, Japan.

DOI: 10.4236/ajac.2013.49061                

Abstract

Non-polar capillary columns for GC/MS are widely utilized in the analysis of additives for food contact materials. Though various kinds of non-polar capillary columns are commercially available, the equality of their performance has not been verified. Herein, ninety-six additives for food contact plastics were analyzed using fifteen kinds of columns, and the peak separation, retention times, and peak areas of each additive were compared. The additives, with various chemical properties, comprised forty four plasticizers, twenty lubricants, twenty antioxidants, nine ultraviolet absorbers, and three other compounds. 10 μg^.mL^-1 test solutions were prepared in acetone, and injected to the GC/MS. The fifteen columns were classified into five categories based on the chromatogram pattern and peak separation. To facilitate comparison of the retention time and detection sensitivity of the columns for the additives, the relative retention time (RRT) and relative peak area (RPA) were calculated by using dibutylphthalate or 4-tert-butylphenylsalicylate as an internal standard. The RRTs of the additives on each column were essentially similar. However, the RRT of the additives which were detected in the later stages differed slightly. Although the RPA of the plasticizers and lubricants were roughly similar, column-to-column differences were observed for certain additives, such as antioxidants and ultraviolet absorbers. Furthermore, certain fatty acids, antioxidants, two plasticizers, and two benzophenone type ultraviolet absorbers were not detected in the chromatograms of two columns.

Keywords

Non-Polar Capillary Column; GC/MS Analysis; Additives for Food Contact Plastics; Relative Retention Time; Relative Peak Area

Conflicts of Interest

The authors declare no conflicts of interest.

References

[1]	M. Peltzer, J. Wagner and A. Jime′nez, “Migration Study of Carvacrol as a Natural Antioxidant in High-Density Polyethylene for Active Packaging,” Food Additives and Contaminants, Vol. 26, No. 6, 2009, pp. 938-946.
[2]	J. H. Petersen and L. K. Jensen, “Phthalates and Food-Contact Materials: Enforcing the 2008 European Union Plastics Legislation,” Food Additives and Contaminants, Vol. 27, No. 11, 2010, pp. 1608-1616. doi:10.1080/19440049.2010.501825
[3]	A. Guart, F. Bono-Blay, A. Borrell and S. Lacorte, “Migration of Plasticizers, Phthalates, Bisphenol A, and Alkylphenols from Plastic Containers and Evaluation of Risk,” Food Additives and Contaminants, Vol. 28, No. 5, 2011, pp. 676-685. doi:10.1080/19440049.2011.555845
[4]	C. Simoneau, L. V. Eede and S. Valzacchi, “Identification and Quantification of the Migration of Chemicals from Plastic Baby Bottles Used as Substitutes for Polycarbonate,” Food Additives and Contaminants, Vol. 29, No. 3, 2012, pp. 469-480.
[5]	L. L. Barnkob and J. H. Petersen, “Effect of Relative Humidity on the Migration of Benzophenone from Paperboard into the Food Simulant Tenax and Modeling Hereof,” Food Additives and Contaminants Part A, Vol. 30, No. 2, 2013, pp. 395-402. doi:10.1080/19440049.2012.741717
[6]	Y. Kawamura, K. Watanabe, K. Sayama, Y. Takeda and T. Yamada, “Simultaneous Determination of Polymer Additives in Polyethylene by GC/MS,” Journal of the Food Hygienic Society of Japan, Vol. 38, No. 5, 1999, pp. 307-318. doi:10.3358/shokueishi.38.5_307
[7]	Y. Kawamura, C. Tagai, T. Maehara and T. Yamada, “Additives in Polyvinyl Chloride and Polyvinylidene Chloride Products,” Journal of the Food Hygienic Society of Japan, Vol. 40, No. 4, 1999, pp. 274-284. doi:10.3358/shokueishi.40.4_274
[8]	Y. Kawamura, C. Tagai, T. Maehara and T. Yamada, “Simultaneous Determination Method of Additives in Polyvinyl Chloride,” Journal of the Food Hygienic Society of Japan, Vol. 40, No. 3, 1999, pp. 189-197. doi:10.3358/shokueishi.40.3_189
[9]	Y. Kawamura, R. Yonezawa, T. Maehara and T. Yamada, “Determination of Additives in Food Contact Polypropylene,” Journal of the Food Hygienic Society of Japan, Vol. 40, No. 2, 2000, pp. 154-161. doi:10.3358/shokueishi.41.154
[10]	Y. Abe, M. Yamaguchi, M. Mutsuga, Y. Hirahara and Y. Kawamura, “Survey of Plasticizers in Polyvinyl Chloride Toys,” Journal of the Food Hygienic Society of Japan, Vol. 53, No. 1, 2012, pp. 19-27. doi:10.3358/shokueishi.53.19
[11]	European Commission, “Commission Regulation 10/2011/ EU of 14 January 2011 on Plastic Materials and Articles Intended to Come into Contact with Food,” Official Journal of the European Union, 2011, pp. 1-89.